Troubleshooting - Studiologic numaorgan2 Operation Manual

Troubleshooting

Troubleshooting
22 NUMA ORGAN 2 by Studiologic®
Problem Possible cause
Numa Organ 2 does not No power is supplied.
turn on. Defective power
cable. Fuse is blown
inside the Numa
Organ 2.
Numa Organ 2 cannot MIDI data are not
be controlled via MIDI. being sent on MIDI
channel 1, 2 or 3.
No sound is heard. Dynamic TOUCH /
[MIDI] is activated.
All drawbars are
pushed all the way in.
Volume is set to 0.
Defective connecting
cable / headphone.
A sustain pedal is
connected to Expres-
sion pedal input.
Only one sound is All drawbars of the
heard in split mode. lower zone are
pushed all the way in.
No sound from the Level of Audio In is
audio input is heard. set to minimum.
External sound de-
vice is not playing.
Defective cable con-
nection.
The Sustain pedal just The Rotary wheel is
changes the Rotary set to Brake.
speed from Brake to
fast, but not Slow to
Fast.
Sustain pedal does not Dynamic TOUCH /
[MIDI] is deactivated.
hold notes if pressed.
Sustain pedal holds The contact of the
notes if it is not pressed, attached sustain
but cuts notes if pedal is closed at rest.
pressed.
Dynamic TOUCH /
Adjustments e.g. of the
drawbars cannot be [MIDI] is deactivated.
recorded with a The MIDI Input of
sequencer program. the sequencer is not
set to MIDI channels
1, 2 and 3 or to "all
inputs".
Solution
Please make sure that
power is available and
switched on. Check
the power cable and
the internal fuse and
replace it if needed,
with a fuse as specified
on page XX..
Please send MIDI data
only on MIDI channel
1, 2 and/or 3.
Deactivate Dynamic
TOUCH / [MIDI].
Pull at least one draw-
bar down.
Set the Volume to a
higher level.
Change the cable /
headphone.
Unplug the sustain
pedal from Expression
pedal in.
Pull at least one draw-
bar down for the silent
zone.
Adjust Stereo Audio In
Level.
Check if the exter-
nal sound device is
sending audio signal.
Change the connec-
tion cable.
Set the position of the
Rotary wheel to Fast
or Slow. Please also
refer to page 12.
Activate Dynamic
TOUCH / [MIDI], if
you want to use the
foot switch as sustain
pedal.
Plug in a sustain pedal
where contact is open
at rest.
Activate Dynamic
TOUCH / [MIDI].
Set the input of the
sequencer to MIDI
channel 1, 2, 3 or to "all
inputs".