Assemble Main Unit - Briggs & Stratton Electric Pressure Washer Operator's Manual

Assemble Main Unit

When performing the following assembly procedures, pay close
attention to the illustration at the bottom of this page.
1. Remove and discard the protective cap (A) from each wheel
shaft.
NOTICE During shipment wheel tabs may compress inward. If
so, gently spread tabs outward.
2. Slide wheel shafts (B) into holes at sides of main unit (C).
Wheels are installed correctly when you hear a CLICK and
they are securely in place.
3. Slide the handle (D) into the slots at top of main unit (C).
Install two (2) screws to secure the handle to the main unit.
4. Slide accessory tray (E) into slots at back of main unit. Install
two (2) screws to secure the accessory tray to the main unit.
A
B
F
H
8
C
G
5. Install stability foot (F) if equipped, and secure using two
screws.
6. Confirm that black rubber gasket (G) is installed in water inlet
located at lower front of unit.
7. Place water tank (H) onto shelf at back of unit.
8. Rotate water tank cap (J) counter-clockwise until it clicks onto
retaining tab. Make sure that end of suction hose contacts
bottom of tank.
9. Place detergent tank (K) onto shelf at front of unit.
10. Rotate detergent tank cap (M) counter-clockwise until it
clicks onto retaining tab. Make sure that end of suction hose
contacts bottom of tank.
D
B
J
E
K
BRIGGSandSTRATTON.COM
M