Connect Hoses And Water Supply; Connect Wand And Spray Tips; Checklist Before Starting Pump Motor; Servicing Of A Double-Insulated Appliance - Briggs & Stratton Electric Pressure Washer Operator's Manual

Connect Hoses and Water Supply

NOTICE Use ONLY cold water (less than 100°F).
1. Attach garden hose (50 ft. / 15.24 m maximum) to water
supply.
2. Run water through garden hose for 30 seconds to flush the
hose of debris. Turn off water.
3. Confirm that black rubber gasket (A) is installed in water inlet
located at lower front of unit.
C
A
B
NOTICE DO NOT run the pump without the water supply
connected and turned on.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
4. Attach opposite end of garden hose (B) to the water inlet
coupling (C). Tighten by hand.
5. Attach high pressure hose (D) to the unit's water outlet (E)
located at lower back of unit. Tighten by hand.
D
6. Attach opposite end of high pressure hose to the spray gun.
Press red button (F) on spray gun, then insert end of high
pressure hose (G) into gun until it SNAPS into place. Release
the red button and make sure connection is secure.
F
G
10
E

Connect Wand and Spray Tips

1. Turn ON water, point gun in a safe direction, press trigger
release (H), then squeeze trigger (J) to purge pump system
and spray gun of air and impurities.
2. Insert and twist wand (K) into spray gun (M). Once wand
slides into gun, apply further inward pressure to wand and
twist 1/4 turn clockwise until securely in place.
K
3. When the metal wand is installed, select the spray tip you
want to use. Pull back on collar of wand (N), insert spray
tip (P) and release collar. Tug on spray tip to make sure it is
securely in place. See How to Use Spray Tips.
N
P
4. Turn OFF water and release trigger. Point gun in a safe
direction and make sure trigger cannot be squeezed.

Checklist Before Starting Pump Motor

Review the unit's assembly to ensure you have performed all of
the following.
1. Be sure to read Operator Safety and Operation before using
the electric pressure washer.
2. Check for properly tightened hose connections.
3. Check to make sure there are no kinks, cuts, or damage to
hoses.
4. Provide a proper water supply at an adequate flow (not to
exceed 100 °F).
5. Plug electrical cord into a properly grounded electrical source.

Servicing Of A Double-Insulated Appliance

In a double-insulated product, two systems of insulation are
provided instead of grounding. No grounding means is provided
on a double-insulated product, nor should a means for grounding
be added to the product. Servicing a double-insulated product
requires extreme care and knowledge of the system, and should
be done only by qualified service personnel. Replacement parts
for a double-insulated product must be identical to the parts they
replace. A double-insulated product is marked with the words
"DOUBLE INSULATION" or "DOUBLE INSULATED."
The symbol means DOUBLE-INSULATED APPLIANCE.
H
M
BRIGGSandSTRATTON.COM
J