Panasonic DMP-BDT465 Operating Instructions Manual page 35

Messages on the unit's display
NET
While connecting to a network.
No PLAY
There is a viewing restriction on a BD-Video
or DVD-Video. (
The media is dirty or badly scratched. The
unit cannot play.
REMOVE
The USB device is drawing too much power.
Remove the USB device.
SET
(" " stands for a number.)
The remote control and this unit are using
different codes. Change the code on the
remote control.
Press and hold [OK] and
the indicated number
button at the same time
for more than 5 seconds.
U59
Temperature of this unit is hot and the unit
switches to standby for safety reasons.
Wait for about 30 minutes.
Install or place this unit with good ventilation.
H or F
(" " stands for a number.)
There is something unusual.
Check the unit using the troubleshooting
guide. If the service number remains
displayed, do the following.
1 Disconnect the plug from the household
mains socket, wait a few seconds, then
reconnect it.
2 Press [Í/I] to turn the unit on.
If the service number remains displayed despite
doing the above, request service from the dealer.
Inform the dealer of the service number when
requesting service.
29)
Reference
START
The system is being restarted during the
firmware update. Please do not turn off the
unit.
UPD /
(" " stands for a number.)
The firmware is being updated.
Please do not turn off the unit.
FIN
The firmware update is complete.
- 35 -