Bissell 53Y8 SERIES User Manual page 8

Main n ce & Care
Brush roll and brush roll belt maintenance continued
Brush roll reset:
If larger debris becomes lodged in the foot of the
unit and the brush roll shuts off, turn the unit off and
remove the obstruction. Wait approximately 15
seconds for the motor to cool down before turning
back on. Brush will function again after allowing time
to cool down.
Brush roll belt replacement:
If the brush roll belt should break, call
1-800-263-2535 or visit www.BISSELL.ca
to purchase replacement belt number 2031608.
Replacement instructions:
1.
Turn power OFF (O). Remove foot assembly
from unit and turn over to access the brush roll
belt.
2.
Remove three Phillips head screws to remove
the belt cover.
3.
Locate broken belt.
4.
Replace belt.
5.
Place brush roll back into foot of unit.
6.
Replace the belt cover and secure with three
screws.
7.
Attach foot assembly on unit.
Disposal of batteries
WARNING:
This product contains Nickel Metal Hydride (NiMH) rechargeable batteries.
According to Federal and State regulations, removal and proper disposal of
NiMH batteries is required. For removal of the batteries in your Lift-Off Floor
& More see instructions below.
If your Lift-Off 2-IN-1 is to be disposed of, the
batteries should be removed and disposed of
properly.
1.
IMPORTANT: Unplug Charger.
2.
Remove hand vac from unit and remove dirt
cup from handle.
3.
Remove (5) Phillips head screws on the handle
and cover.
w w w . b i s s e l l . c a
8
2.
3.
TM
3.
5 screws
1 - 8 0 0 - 2 6 3 - 2 5 3 5