Setup and Interconnections
Interconnections
1. Turn the transceiver power off, also turn off the main power switch on the transceiver rear panel. (press the [ O ] side of the
rocker switch)
2. Referring to the illustration, connect the speaker cable from the SP-2000 INPUT 1 jack to the transceiver's EXT SPKR jack.
The audio from the transceiver speaker will then be muted.
Using the Extender Feet
You may tilt the speaker upward by extending the front feet of the enclosure.
Pull the feet out and rotate each foot counter-clockwise to
lock it into the extended position.
Note: Please take care that each foot locks securely in place.
Unless the feet are locked securely, there is a possibil-
ity the enclosure could suddenly tip back down. care
when locking the feet in place.
To Shorten the Extender Feet
Rotate each foot clockwise, out of the "lock" position, and
press it in.
Speaker Cable
(Supplied w/SP-2000)
E
R
XTEND
ETRACT