Table of Contents
Advertisement
BP7332-2 CF930 Atomical
2. Loosen setscrew in motor coupling if
necessary. Separate, untwist and
unkink the three 80" motor leads. Route
the motor lead wires through the
downrod. Align the clevis pin holes in
the downrod with the holes in the motor
coupling. Install the clevis pin and
secure with the hairpin clip (Figure 2).
The clevis pin must go through the
holes in the motor coupling and the
holes in the downrod. Be sure to push
the straight leg of the hairpin clip
through the hole near the end of the
clevis pin until the curved portion of the
hairpin clip snaps around the clevis pin.
The hairpin clip must be properly
installed to prevent the clevis pin from
working loose. Pull on the downrod to
make sure the clevis pin is properly
installed.
WARNING
!
It is critical that the clevis pin in the motor
coupling is properly installed and the
setscrew securely tightened. Failure to
verify that the pin and setscrew are
properly installed (as shown in Figure 2)
could result in the fan falling.
SETSCREW (2)
SETSCREW
CLEVIS PIN
CLEVIS PIN
Figure 2
9/23/10
3:29 PM
Page 6
3. While pulling up on the downrod,
securely tighten the two setscrews in
the motor coupling (Figure 3).
NOTE: The setscrews must be properly
installed as described above, or fan
wobble could result.
4. Make sure the grommet is properly
installed in the coupling cover then
slide the coupler cover on the downrod
until it rests on the motor housing.
Place the ceiling cover over the
downrod. Be sure both the ceiling cover
and the coupler cover are oriented
correctly (Figure 3).
HAIRPIN
CLIP
MOTOR
COUPLING
Figure 3
DOWNROD
DOWNROD
HAIRPIN
HAIRPIN CLIP
CLIP
MOTOR
COUPLING
MOTOR
COUPLING
6
CEILING
CANOPY
COUPLER
COVER
CLEVIS PIN
SETSCREW (2)
UL Model No.: CF930
Advertisement
Table of Contents
