Input Select - Denon AVR-S500BT Owner's Manual

Contents Connections

Input Select

Set the audio input mode and decode mode of each input source.
The input modes available for selection may vary depending on the input
source.
"Input Select" settings are stored for each input source.
o Input Mode
Set the audio input modes for the different input sources.
It is normally recommended to set the audio input mode to "Auto".
Auto
(Default):
HDMI:
Digital:
Analog:
When digital signals are properly input, the ~ indicator lights on the display. If
the ~ indicator does not light, check "Input Assign" and the connections.
(v p. 75)
Front panel Display
Playback
Automatically detect input signal and
perform playback.
Play only signals from HDMI input.
Play only signals from digital audio input.
Play only signals from analog audio input.
Rear panel
Settings
o Decode Mode
Set the audio decode mode for input source.
It is normally recommended to set the audio input mode to "Auto". But
we recommend changing it to "PCM" or "DTS" if the start of the source
is clipped or noise occurs.
Auto
(Default):
PCM:
DTS:
This item can be set for input sources for which "COAXIAL", "OPTICAL1" or
"OPTICAL2" is assigned at "Input Assign" (v p. 75).
76 Remote
Tips Appendix
Detect type of digital audio input signal
and decode and play automatically.
Decode and play only PCM input signals.
Decode and play only DTS input signals.
Index