Performing Several Commands In Sequence; Automatically (Macro Play) - Sony STR-DB940 Operating Instructions Manual

Performing Several Commands in Sequence Automatically
(Macro Play)
The Macro Play function lets you link several IR codes in
a sequential order as a single command The remote
provides 2 macro lists (MACRO 1 and 2) You can specify
up to 8 IR codes for each macro list
Press SET Up.
The set up list appears
Move the easy scroll key to select "IR SET," then
press the key to enter the selection
The IR SET list appears
Move the easy scroll key to select "MACRO 1" (or
"MACRO 2"). then press the key to enter the
selection
The PROGRAM list appears
Move the easy scroll key to select the macro step
number ("Macro l-l" for example) then press the
key to enter the selection
The CATEGORY list appears
Move the easy scroll key to select the component
category ("VCR" for example) then press the key to
enter the selection
The MAKER list appears
Move the easy scroll key to select the maker, then
press the key to enter the selection For pre-
programmed functions, "*" is displayed in front of
the function, for example, "* PLAY"
The FUNCTION list appears
Move the easy scroll key to select the IR code for
the operation you want to perform, then press the
key to enter the selection
The PROGRAM list reappears
Repeat steps 4 through 7 to program up to 8 IR
codes
When you have finished programming IR codes,
select "EXIT" in step 7
To cancel programming
Move the easy scroll key to select "EXIT" or "CANCEL"
during any step, then press the key to enter the selection
To erase a programmed IR code
Move the easy scroll key to select "NO SET" from the
FUNCTION list, then press the key to enter the selection
To turn off all connected Sony components
(SYSTEM STANDBY)
Move the easy scroll key to select "ALL OFF" from the
FUNCTION list, then press the key to enter the selection
However, this function cannot apply to some Sony
components
To delay the output of an IR code
Move the easy scroll key to select "WAIT TIME" from the
FUNCTION list, then press the key to enter the selection
This allows you to specify a 1 to 10 second delay (in
1 second increments) before outputting the IR code
17