Introduction; Store Conditions; Safety Instructions; General Recommendations - Master Bilt MSC30 Installation & Operation Manual

INTRODUCTION

Thank you for purchasing a Master-Bilt cabinet. This manual contains important instructions for
installing, using and servicing a MSC/MSF case. A parts list is included in with this manual. Read all
these documents carefully before installing or servicing your equipment.

STORE CONDITIONS

The MSC/MSF case are designed to operate in the controlled environment of an air-conditioned store.
The store temperature should be at or below 75°F and a relative humidity of 55% or less. At higher
temperature or humidity conditions, the performance of these cases may be affected and the capacity
diminished. It is not uncommon in a newly constructed store for the temperature and humidity to be
above design conditions. These excessive conditions may produce sweating in the case until the store
is operational and the ambient environment is more desirable.

SAFETY INSTRUCTIONS

General Recommendations

This symbol is the safety-alert symbol. When you see this symbol on your cabinet or in
this manual, be alert to the potential for personal injury or damage to your equipment.
- Read this manual before installing your cabinet. Keep the manual and refer to it before
doing any service on the equipment. Failure to do so could result in personal injury or
damage to the cabinet.
- Improper or faulty hook-up of electrical components of the refrigeration units can result
in severe injury or death.
- All electrical wiring hook-ups must be done in accordance with all applicable local,
regional or national standards.
- Installation and service of the refrigeration and electrical components of the cabinet
must be performed by a refrigeration mechanic and/or a licensed electrician.
The portions of this manual covering refrigeration and electrical components contain technical
instructions intended only for persons qualified to perform refrigeration and electrical work.
This manual cannot cover every installation, use or service situation. If you need additional information
have the serial number at hand and call or write us:
Customer Service Department
Master-Bilt Products
Highway 15 North
New Albany, MS 38652
Phone (800) 684-8988
Fax (800) 684-8988
3