Advertisement
Battery Installation
1.
Remove the battery cover by pressing in on
the upper lip of the cover then pull it out.
2.
Place two AA Batteries in the Battery
Housing. Be sure that the polarities
(+ or -) of the batteries line up with
the polarity signs in the battery
housing. Replace the battery cover.
Camera Installation
1.
Chose a wall or ceiling location that allows
you to mount the unit onto a solid surface
capable of sustaining the weight of the unit.
It is recommended that you choose a location
that is out of the reach of pedestrians.
Note: Verify that installation surface has no
hidden utility lines before drilling or driving screws.
2.
You can make a pattern of the mounting
holes by placing a piece of tracing paper
over the back of the Camera and trace
the mounting holes location using a pen
or pencil. Hold the pattern over the area
that you want to install the camera. Mark
the center of each mounting hole by
hammering a nail through the pattern into
the mounting surface. Attach the screws
to the mounting surface leaving about a
1/4" of the screws' shanks exposed.
3.
After the mounting screws have been
attached to the wall or ceiling, place the
two mounting holes on the camera over the
screw heads. Press the Dome Camera over
the screw heads and move the camera so
that the screws are secured in the keyholes.
Note: The mounting holes on the Imitation Dome
Camera are approximately 1/4" with 5/32" slots.
Note: There are no replacement
parts available for this product.
Item 95154
For technical questions, please call 1-888-866-5797.
3.
The light will automatically blink in 5 second
intervals until the batteries go dead. When
the light stops blinking, replace the batteries.
Mounting Holes
Figure A
Page 3
Advertisement
