Do you have a question about the 95154 and is the answer not in the manual?
Questions and answers
Sergio Giron
May 3, 2025
Como conectar mi cámara al telefono
1 comments:
Mr. Anderson
May 17, 2025
The Bunker Hill Security camera model 95154 is an imitation dome camera with a blinking LED light. It does not have any real video recording or wireless transmission capabilities. Therefore, it cannot be connected to a phone.
This answer is automatically generated
Isidro
February 22, 2025
How work the cámara
1 comments:
Mr. Anderson
February 22, 2025
The Bunker Hill Security Imitation Dome Camera model 95154 is a fake security camera designed to deter potential intruders. It operates using two AA batteries (not included), which power a blinking LED light. Once the batteries are installed, the light blinks at 5-second intervals until the batteries run out. The camera does not record video or provide real surveillance; it is meant to create the appearance of a real security camera.
This answer is automatically generated
Orlando Hernandez
February 18, 2025
Para conectar esta cámara como hago
1 comments:
Mr. Anderson
February 18, 2025
The Bunker Hill Security camera with part number 95154 is an imitation dome camera with an LED and does not require a wired connection. To install it:
1. Battery Installation: - Remove the battery cover by pressing in on the upper lip and pulling it out. - Insert two AA batteries, ensuring the correct polarity (+ and -). - Replace the battery cover. The LED will blink every 5 seconds until the batteries are dead.
2. Mounting the Camera: - Choose a solid wall or ceiling location that can support the unit’s weight and is out of reach of pedestrians. - Ensure there are no hidden utility lines before drilling. - Use tracing paper to mark the mounting hole positions. - Secure the camera using screws through the mounting holes.
Since this is an imitation camera, no additional wiring or connectivity is needed.
Always wear ANSI-approved impact safety goggles during installation. maintain with care. Keep the Imitation Dome Camera clean for better and safer performance. For technical questions, please call 1-800-444-3353 SKU 95154 SpeciFicationS 1.5V DC “AA” Batteries (Qty. 2) (not included) 4-5/8” D X 3” H 360°...
Use of any other parts will void the warranty. Only use accessories intended for use with this product. Approved accessories are available from Harbor Freight Tools. 11. do not install the imitation dome camera if under the influence of alcohol or drugs.
5 second intervals until the batteries go dead. When the light stops blinking, replace the batteries. Battery Housing note: There are no replacement parts available for this product. For technical questions, please call 1-800-444-3353 SKU 95154 cameRa inStallation opeRation Mounting Holes FiguRe 1...
Need help?
Do you have a question about the 95154 and is the answer not in the manual?
Questions and answers
Como conectar mi cámara al telefono
The Bunker Hill Security camera model 95154 is an imitation dome camera with a blinking LED light. It does not have any real video recording or wireless transmission capabilities. Therefore, it cannot be connected to a phone.
This answer is automatically generated
How work the cámara
The Bunker Hill Security Imitation Dome Camera model 95154 is a fake security camera designed to deter potential intruders. It operates using two AA batteries (not included), which power a blinking LED light. Once the batteries are installed, the light blinks at 5-second intervals until the batteries run out. The camera does not record video or provide real surveillance; it is meant to create the appearance of a real security camera.
This answer is automatically generated
Para conectar esta cámara como hago
The Bunker Hill Security camera with part number 95154 is an imitation dome camera with an LED and does not require a wired connection. To install it:
1. Battery Installation:
- Remove the battery cover by pressing in on the upper lip and pulling it out.
- Insert two AA batteries, ensuring the correct polarity (+ and -).
- Replace the battery cover. The LED will blink every 5 seconds until the batteries are dead.
2. Mounting the Camera:
- Choose a solid wall or ceiling location that can support the unit’s weight and is out of reach of pedestrians.
- Ensure there are no hidden utility lines before drilling.
- Use tracing paper to mark the mounting hole positions.
- Secure the camera using screws through the mounting holes.
Since this is an imitation camera, no additional wiring or connectivity is needed.
This answer is automatically generated