Sony Handycam HDR-CX360 Operating Manual page 104


Notes
If you close the LCD screen while recording movies, the camcorder stops recording.

The maximum continuous recordable time of movies is about 13 hours.

When a movie file exceeds 2 GB, the next movie file is created automatically.

It will take several seconds until you can start recording after you turn on the camcorder. You cannot

operate your camcorder during this time.
The following states will be indicated if data is still being written onto the recording media after recording

has finished. During this time, do not apply shock or vibration to the camcorder, or remove the battery or
AC Adaptor.
Access lamp (p. 23) is lit or flashing

The media icon in the upper right of the LCD screen is flashing

Tips

You can record photos during movie recording by pressing PHOTO fully (Dual Rec, p. 40).

[ SteadyShot] is set to [Active] in the default setting.

You can specify the priority face by touching it (p. 38).

You can capture photos from recorded movies (p. 55).

You can check the recordable time, estimated remaining capacity, etc., by touching

[Setup]  [ (Media Settings)]  [Media Info].
The LCD screen of your camcorder can display recording images across the entire screen (full pixel

display). However, this may cause slight trimming of the top, bottom, right and left edges of images when
played back on a TV which is not compatible with full pixel display. In this case, set [Guide Frame] to
[On] (p. 86), and record images using the outer frame displayed on the screen as a guide.
To adjust the angle of the LCD panel, first open the LCD panel 90 degrees to the camcorder (), and

then adjust the angle ().
 90 degrees (max.)
 180 degrees (max.)
Data code during recording
The recording date, time and condition , and coordinates (HDR-CX360V/PJ30V/PJ50V) are
recorded automatically on the recording media. They are not displayed during recording.
However, you can check them as [Data Code] during playback. To display them, touch
(MENU)  [Setup]  [
.
(Playback Settings)]  [Data Code]  a desired setting 
US
6
(MENU) 
 90 degrees to the
camcorder