Maintenance - JVC KD-S100 Instructions Manual

Maintenance
• How to clean the connectors
Frequent detachment will deteriorate the connectors.
To minimize this possibility, periodically wipe the
connectors with acotton swab or cloth moistened with
alcohol, being careful not to damage the connectors.
• To keep discs dean
Adirty disc may not play correctly.
~.
If adisc does become dirty, wipe it with . ,
asoft cloth in astraight line from center
to edge.
• Do not use any solvent (for example, conventional
record cleaner, spray, thinner, benzine, etc.) to clean
discs.
Center holder
Connector
Do not use the following dis(s:
Warped disc
-#
• How to handle SO card
SD cards are precision products. DO NOT impact, bend,
drop, or wet them.
*
Stick-on label
S t i c k e r . Sticker residue
• To play new discs
New discs may have some rough spots
around the inner and outer edges. If
such adisc is used, this unit may reject
the disc.
To remove these rough spots, rub the edges with a
pencil or ball-point pen, etc.
When removing adis( from its
(ase, press down the center holder
of the case and lift the disc out,
holding it by the edges.
• Always hold the disc by the edges. Do not touch its
recording surface.
When storing adis( into its (ase, gently insert the
disc around the center holder (with the printed surface
facing up).
• Make sure to store discs into the cases after use.
• How to handle discs
• Moisture condensation
Moisture may condense on the lens inside the unit in
the folloWing cases:
• After starting the heater in the car.
• If it becomes very humid inside the car.
Should this occur, the unit may malfunction. In this
case, eject the disc and leave the unit turned on for a
few hours until the moisture evaporates.