Table of Contents
Advertisement
Quick Links
73-1911-250
8/00
ready-to-run O-27 set
Owner's Manual
CAUTION—ELECTRIC TOY
NOT RECOMMENDED FOR CHILDREN UNDER EIGHT YEARS
OF AGE. AS WITH ALL ELECTRIC PRODUCTS, PRECAU-
TIONS SHOULD BE OBSERVED DURING HANDLING AND
USE TO REDUCE THE RISK OF ELECTRIC SHOCK.
TRANSFORMER RATINGS—INPUT: 120 VAC; 60 HZ ONLY.
AC OUTPUT: 20 V; 54 VA
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Lionel Snap-On
Summary of Contents for Lionel Snap-On
- Page 1 73-1911-250 8/00 ready-to-run O-27 set Owner’s Manual CAUTION—ELECTRIC TOY NOT RECOMMENDED FOR CHILDREN UNDER EIGHT YEARS OF AGE. AS WITH ALL ELECTRIC PRODUCTS, PRECAU- TIONS SHOULD BE OBSERVED DURING HANDLING AND USE TO REDUCE THE RISK OF ELECTRIC SHOCK. TRANSFORMER RATINGS—INPUT: 120 VAC; 60 HZ ONLY. AC OUTPUT: 20 V;...
-
Page 2: Table Of Contents
Congratulations! ou’re now the proud owner of the Snap- maintenance procedures to help your Lionel on ready-to-run O-27 train set. trains live long, healthy lives. Everything you need to get started is includ- If you have any questions after reading ed. - Page 3 1-800-4-Lionel for a (when applicable) are correct. Service Center near you. The parts list below will tell you what’s •...
-
Page 4: Track Layout
Lionel a track pin into one rail at maintenance kit (no. 6- a time before joining the 62927), available from your entire track section. nearest Lionel Authorized If the openings become too open (causing Value Added Dealer or Lionel Service. -
Page 5: Attaching The Lockon To The Track
Track layout Attaching the lockon to the track he lockon connects power from your upward so that the spring contact snaps controller to the track. Attaching the onto the center rail. The lockon should face lockon to the track is quick and easy. First, outward when setting up your track and place the lockon under any straight section make sure it is firmly connected. -
Page 6: Controller Operations
Controller operations Stripping the wire nce your track is assembled and stripped back about 1⁄4" to 3⁄8". To the lockon is strip the wires, use a pair securely attached, of wire strip- you can connect pers or a the wires from the sharp knife. -
Page 7: Attaching The Controller Wires To The Lockon
Controller operations Attaching the controller wires to the lockon ow you’ll need to insert a controller small plug end of the power pack into the wire into each of the two spring clips back of your controller, and plug the other on the lockon. -
Page 8: Controller Functions
Controller operations Controller functions s you turn the throttle control knob to more cars for the engine to pull, for exam- the right, power to the track is ple), the farther into the green the knob increased. When the indicator reaches the must be turned before it will operate the green band, there should be sufficient power locomotive. -
Page 9: Controller And Short Circuits
Controller operations Controller and short circuits our Lionel power pack is listed by cause of short circuits, so make sure that all Underwriters Laboratories Inc. and has wheels are properly set on the rails. Some been carefully designed and tested to ensure... -
Page 10: Train Operation
Train operation Reverse unit procedure he reverse unit inside your Lionel loco- the switch is thrown back, the locomotive motive is an electronic device that acts will be “locked” in neutral. If the switch is like the transmission in your car. When you... -
Page 11: Tire Traction
Keep in mind that it’s easier to couple cars on a straight stretch of track. In order to get your Snap-on train completely ready for departure, you will need to Note! fold up the Snap-on simulated cargo load and place it between the bulkheads on... -
Page 12: Maintaining And Servicing Your Set
Pull the lamp straight out and through the slot in the front truck assembly replace it with Lionel part no. 600-0161- and secured under one of the two front 300, available from your nearest Lionel screws. -
Page 13: Lubricating Your 4-4-2 Locomotive
You’ll know your 4-4-2 requires lubrica- We recommend you purchase a Lionel tion when visual inspection reveals dryness Lubrication and Maintenance Kit (no. 6- on the parts indicated in the illustration. -
Page 14: Adding Smoke Fluid To Your 4-4-2'S Smoke Generator
The smoke generator requires the periodic damaged if operated without smoke fluid. addition of Lionel smoke fluid in order to This is particularly true if your locomotive function. Pierce the smoke fluid tube end... -
Page 15: Notes
NOTES:... -
Page 16: Limited Warranty/Lionel Service
Station, together with proof of original purchase Please make sure you have followed all of the will, at the option of Lionel L.L.C., be repaired or above instructions carefully before returning any replaced, without charge for parts or labor. In the merchandise for service.
Need help?
Do you have a question about the Snap-On and is the answer not in the manual?
Questions and answers