Projecting Images
Switching to the Target Image by Remote Control
You can change directly to the target image by pressing the following
buttons on the remote control.
The input ports for each button are shown below.
E
Changes to images from a computer connected via the network. See the following
section to check the position of the LAN port.
s "Interface"
p.9
Remote control
Input Port
Adjusting the Volume
You can adjust the volume using one of the following methods.
• Press the [Volume] button on the remote control to adjust the volume.
[
] Decreases the volume.
a
[
] Increases the volume.
b
• Adjust the volume from the Configuration menu.
Settings - Volume
p.77
s
Caution
Do not start at high volume.
A sudden excessive volume may cause loss of hearing. Always lower the volume
before powering off, so that you can power on and then gradually increase the
volume.
Remote control
39