Epson EB-4955WU User Manual page 96

Problem Solving
B
Lamp indicator
C
Temp indicator
D
Filter indicator
Refer to the following table to see what the indicators mean and how to remedy problems that they indicate.
If all indicators are off, check that the power cord is connected correctly and that the power is being supplied normally.
Sometimes, when the power cord is unplugged, the [
Status Cause
Internal Error
Fan Error
Sensor Error
High Temp Error
(Overheating)
Warming up
Warm-up time is about 30 seconds. After warm-up is complete, the indicator stops flashing.
The [t] button is disabled during warm-up.
Projecting
Indicates the projection lamp status.
Indicates the internal temperature status.
Indicates the air filter status.
] indicator remains lit for a short period, but this is not a fault.
t
Stop using the projector, remove the power plug from the electrical outlet, and contact your local dealer or the nearest address provided in the
Epson Projector Contact List.
Epson Projector Contact List
s
Stop using the projector, remove the power plug from the electrical outlet, and contact your local dealer or the nearest address provided in the
Epson Projector Contact List.
Epson Projector Contact List
s
The lamp turns off automatically and projection stops. Wait for about five minutes. After about five minutes the projector switches to standby
mode, so check the following two points.
• Check that the air filter and air exhaust vent are clear, and that the projector is not positioned against a wall.
• If the air filter is clogged, clean or replace it.
s "Cleaning the Air Filter" p.112
s "Replacing the Air Filter" p.118
If the error continues after checking the points above, stop using the projector, remove the power plug from the electrical outlet, and contact
your local dealer or the nearest address provided in the Epson Projector Contact List.
Epson Projector Contact List
s
: Lit : Flashing : Off : Varies according to the projector status
Remedy or Status
96