HUSTLER FasTrak 36" & 42" Decks none Parts Manual page 91

.06"-.125"
BRAKE
GEAR
BRAKE
LEVER ARM
WARNING:
the FasTrak 36/42.This procedure requires that the engine be running and the drive wheels
rotating during adjustment.
WARNING:
Make certain the engine is not running when adjusting the steering rods. The neutral adjustment
for the control levers in the neutral position is discussed in this section.
Control lever neutral adjustment
Before considering any adjustment, check the tire air pressure. Unequal tire pressure will cause the tractor
to drift to one side. Refer to tire pressure information in the Maintenance section of this manual.
NOTE:
lever neutral adjustment can be done.
Fine adjustment to the unit's steering is made with the adjustable pump linkage rods(FIG. 24).
Neutral is properly adjusted when the control levers are in the park brake position and the EZT transmis-
sions do not "whine" .
If this occurs, the control linkage may be adjusted as follows:
1. Raise and block the tractor frame keeping the rear drive tires free and clear of any
obstructions so they are free to rotate. The engine will be running and tires rotating
during this operation.
WARNING:
stands. Make certain machine is secure when it is raised and placed on the jack stands. The jack
stands should not allow the machine to move when the engine is running and the drive wheels are
Use only certified jack stands.
rotating.
weight rating of2000 pounds to block the unit up. Use in pairs only. Follow the instructions
333559 09/08
GAP
FIG. 21
ADJUSTING
TUBE
Only properly trained personnel should attempt to reset the neutral adjustment on
The adjustable steering rods are located near the EZT integrated pump/motor fans.
Proper park brake adjustment must be completed before the control
Never work under the machine or attachment unless it is safely supported with jack
BRAKE
GEAR
BRAKE
LEVER ARM
JAM
NUT
FIG. 23
Use only appropriate jack stands, with a minimum
9-21
LOCK
NUT
7/8"
FIG. 22