Cub Cadet Tank SZ Operator's Manual page 32

2. Remove the flange lock nut and carriage bolt securing
the front deck wheel and spacer to the deck. Remove the
wheel and carriage bolt. Refer to Fig. 6-5.
Carriage Bolt
Spacer
3. Determine which index hole will give the deck wheel a 1⁄4"
to 1⁄2" clearance with the ground.
4. Insert the carriage bolt through the appropriate index hole
in the deck wheel bracket, through the spacer, the deck
wheel and out the other side of the bracket.
5. Note the index hole of the just adjusted wheel, and adjust the
other deck wheel to the same height as instructed in step 3.
Brakes
The parking brake handle should engage with moderate force.
The brake cable should not require adjustment, but if necessary
proceed as follows:
1. Flip up the seat and secure in place with the seat prop.
Remove the battery as instructed in the Service section.
NOTE: There is a cable for each of the transmissions, be
sure to adjust both cables.
32 S 6— M
ection aintenance
Flange Lock Nut
Deck Wheel
Figure 6-5
& a
djuStMentS
2. Adjust the cable housing nuts one full turn and check
parking capacity. Repeat if parking brake does not hold.
See Fig. 6-6.
Handbrake
Bracket
Cable Housing Nut
Left Transmission
Figure 6-6
NOTE: To adjust the right transmission cable, it is recommended
that you remove the left transmission cable by loosening it until
Z-fitting can be removed from the handbrake bracket. After
adjusting the right brake cable, re-install the left brake cable and
adjust as necessary.
Removing/Installing the Inner Baffle
The inner flow-control baffle can be removed depending on the
mowing conditions. The baffle controls discharge and can be
removed for high-volume grasses and installed for precision cutting.
1. Remove the carriage bolts, push nuts and flange lock nuts
that secure the baffle to the deck to mow high-volume
grasses. See Fig. 6-7.
Carriage Bolts
Push Nut
Figure 6-7
2. Re-install the inner baffle for precision cutting and make
sure the baffle is properly secured.
Right
Transmission
Push Nut
Inner Baffle
Flange
Lock
Nuts