Cub Cadet Tank SZ Operator's Manual page 15

Table of Contents

Advertisement

The mechanical suspension mechanism incorporates weight/
ride adjustment controls for operators in the 125 to 275 lb.
weight range (turn the knob on the front of the seat clockwise to
increase the weight capacity and counter-clockwise to decrease.
NOTE: The seat base must be secured by the latch, otherwise, the
seat assembly could tilt forward. The Operator Presence Sensor
must be connected to the electrical wiring harness.
Connecting the Battery Cables
CALIFORNIA PROPOSITION 65 WARNING
Battery posts, terminals, and related accessories
contain lead and lead compounds, chemicals known
to the State of California to cause cancer and
reproductive harm. Wash hands after handling.
CAUTION:
When attaching battery cables, always
connect the POSITIVE (Red) wire to its terminal first,
followed by the NEGATIVE (Black) wire.
For shipping reasons, both battery cables on your equipment
may have been left disconnected from the terminals at the
factory. To connect the battery cables, proceed as follows:
1.
Using the lever on the back of the seat frame, lift up on the
lever and tilt the seat forward.
NOTE: The positive battery terminal is marked Pos. (+). The
negative battery terminal is marked Neg. (–).
NOTE: If the positive battery cable is already attached, skip ahead
to step 2.
2.
Remove the red boot, if present, from the positive battery
terminal and attach the red cable to the positive battery
terminal (+) with the bolt and hex nut. See Fig. 3-11.
Figure 3-11
3.
Position the red boot over the positive battery terminal to
insulate it and help protect it from corrosion.
4.
Attach the black cable to the negative battery terminal (–)
with the bolt and hex nut. See Fig. 3-11.
NOTE: If the battery is put into service after the date shown on
top/side of battery, charge the battery prior to operating the
machine.
:
S
2 — A
& S
-U
ection
SSembly
et
15
p

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents