Formatting The Hard Drive - Digimerge DNR300 Series Instruction Manual

Formatting the Hard Drive

After installing a new hard drive, you must format it before the system can recognize it.
ATTENTION: Formatting the HDD erases
cannot be undone
To format a hard drive:
1. From Live View, right-click and select Main Menu>Advanced>HDD Management.
2. Under HDD No., select the hard drive you would like to format. Information about the hard
drive appears in the lower section of the menu.
3. Under Set to, select Format.
4. Click Apply. Click OK to confirm. Wait for the hard drive to format. Hard drives become Read/
Write hard drives by default when formatted.
Select HDD
Select Format
Click Execute
. System settings will not be erased.
all data
on the hard disk.
Appendix F: Hard Drive Installation
This step
107