Download Print this page

Hyundai REMOTE START Quick Reference Manual

Hide thumbs Also See for REMOTE START:

Advertisement

Quick Links

REMOTE START QUICK REFERENCE GUIDE
Press for Progressive CarFind
x1= 5 Soft Chirps
x2= 5 Louder Chirps
x3= 5 Full Volume Chirps
Press and Hold for Personal
Protection Alarm
Press to DISARM Security System
and unlock Driver's Door. Press
again Within 5 Seconds to Unlock
All Doors and the Tailgate.
Press and Hold to Open the Trunk /
Hatch / Tailgate Glass, if Equipped

Using the Remote Start Function

Using Valet/Service Mode
Service mode is used when servicing the vehicle to prevent the system from unexpectedly
starting the engine while being serviced. While in service mode, the system's keyless entry
functions will operate normally, but the security system will not arm and the remote start function
is temporarily disabled. The system will honk the horn 2 times if an attempt is made to
activate the remote start system.
To Engage Valet/Service Mode; turn the ignition key to the ON or RUN position and press and
hold the
button for 2 seconds on the remote control transmitter.
To Exit Valet/Service Mode (Return the system to its normal operating mode); turn the
ignition key to the ON or RUN position and press and hold the
remote control transmitter.
Important Note: When taking your vehicle to the dealer for service, it is recommended that you
inform the service personnel that your vehicle is equipped with a remote control start system.
Press to Arm the Security
System and Lock the Doors.
Vehicle entrances are protected
10 seconds after arming the
security system.
Press
then
to activate
Remote Start. Press again to
turn on rear defroster after remote
started if equipped.
button for 2 seconds on the

Advertisement

loading

Summary of Contents for Hyundai REMOTE START

  • Page 1: Using The Remote Start Function

    While in service mode, the system’s keyless entry functions will operate normally, but the security system will not arm and the remote start function is temporarily disabled. The system will honk the horn 2 times if an attempt is made to activate the remote start system.
  • Page 2: Emergency Override Procedure

    2. Insert your key into the ignition and turn it to the ON position. 3. Press the override/programming button secured to the remote start wire harness above the driver’s kick panel. The vehicle alarm will stop sounding and Disarm Button the vehicle will be able to be started with the key.