Copy OEM Logo Here
(→)
Application Notes
Ensure vehicle does NOT have SMART KEY (PUSH BUTTON IGNITION SYSTEM).
Vehicle should be equipped with automatic transmission, power door locks, and power windows. If these features are not equipped on the vehicle, do not proceed with install.
Instructional Symbols / Definitions
Denotes warnings that may lead to serious
physical injury or vehicle damage
Denotes cautions to be taken to avoid
physical injury or electronic component
damage
Denotes cautions to be taken to avoid
vehicle and component damage
Basic Required Tools
10mm Deep Well
Ratchet
Socket
Trim Removal Tool
Clean Cloth
Part Weight (Gross)
FMVSS 110 Compliance Information
All dealers must determine if the weight they have added in the form of all options or accessories, when added to the weight of all Port/Dealer Installed
0.87
lbs
options or accessories, exceeds the lesser of 1.5% of GVWR or 100 lbs. If the additional weight does exceed the lesser of the indicated thresholds, a "Load
Carrying Capacity Reduced" label must be installed. A black, fine-point, indelible marker must be used to write by hand onto the label, the reduced carrying
0.39
kg
capacity in kilograms or pounds, which is the total weight of all added options and accessories.
Load Label Part Number: NP070-09003
Technical Support
Notes to the installer:
1
Read the entire Installation Instructions prior to beginning the installation of the part.
2
Make sure the vehicle is completely clean and dry in the area(s) the part is to be installed.
3
Ensure the vehicle is properly protected in the area(s) that the accessory is to be installed.
4
NEVER place tools on painted surfaces, seating surfaces, dash pad, console or floor carpet/mats.
5
Always wear appropriate personal protective equipment, including gloves, safety glasses, etc., when required.
6
Record radio presets prior to disconnecting battery power, if needed.
7
Roll down the driver's window and adjust the power seats (if applicable) prior to disconnecting battery power, if needed.
8
To prevent stress on the remote start wire harness, ensure the tilt steering column is fully extended before installing the kit.
9
Vehicle should be at room temperature.
The order of the disassembly and reassembly steps have been optimized for maximum efficiency and the correct
10
installation of the Remote Engine Start kit. Disassemble vehicle components (including harness connectors) and
install the kit components according to each step, as indicated. Avoid disassembling or reassembling any
components in advance to prevent unnecessary labor time and/or installation errors.
Genuine Accessories
Vehicle Model:
Santa Fe
Model Year
2019~
Part No.
S2F57 AC300
Language English
Rev. Date
5/3/2018
Vehicle must be equipped with mechanical key start.
Denotes quality processes to be checked
prior to moving to the next step
Denotes specific tools that are necessary
to complete a step
N
O
Denotes important information to be
T
reviewed during the step
E
12mm Socket
8mm Socket
50/50 Isopropyl Alcohol
Torque wrench
(70%) and Water Mix
Authorized dealers use:
(1) 855-225-7344
Hours:
M~F - 9am~5pm Pacific Standard Time
Revision Date
5/03/2018
Accessory:
Remote Engine Start - Key Start
Difficulty:
( B )
Difficulty stated above reflects the minimum level of
Note:
expertise required to install the accessory:
(A) Customer
(B) Dealer Technician
(C) Master Technician or Specialist
Denotes personal protective equipment (PPEs) that
may be required for a step. Examples of safety
equipment icons noted below:
Glasses
Mask
Hearing Protection
#2 Phillips
Extension
Screwdriver
Gloves
Wire Cutters
Page 1 of 11