Emerson CF921BS01 Owner's Manual page 6

3. Make sure the grommet is properly installed in the
coupling cover, then slide the coupling cover on the
downrod until it rests on the motor housing. Place the
ceiling cover over the downrod. Be sure that the
ceiling cover and the coupling cover are both
oriented correctly (Figure 3).
4. Reinstall the hanger ball (Figure 3) on the downrod
as follows. Route the two 80" motor leads through the
hanger ball. Position the pin through the two holes in
the downrod and align the hanger ball so the pin is
captured in the groove in the top of the hanger ball.
Pull the hanger ball up tight against the pin and
securely tighten the setscrew in the hanger ball. A
loose setscrew could create fan wobble.
WARNING
!
It is critical that the pin in the hanger ball is properly
installed and the setscrew securely tightened. Failure
to verify that the pin and setscrew are properly
installed could result in the fan falling.
5. The fan comes with black and white leads that are
80" long. Before installing fan, measure up
approximately 6 to 9-inches above top of hanger
ball/downrod assembly. Cut off excess leads and
strip back insulation 1/2-inch from end of leads.
6. Carefully turn the partially assembled ceiling fan over
and set it on the shipping styrofoam for blade
installation.
7. Remove the shipping spacers and the spacer
attachment screws from the motor before installation
of blade assemblies. Discard the spacers and spacer
screws (Figure 4).
8. Mount blade flanges to fan blades (sold separately)
using four #10-24 x 12mm washer head blade
screws and four 16mm flat washers (Figure 5).
NOTE: Some accessory blades available are
supplied with shorter screws. These shorter screws
MUST be used to assemble the blades to flanges.
NOTE: Take care not to scratch fan housing when
installing blades.
NOTE: Remove and discard the four shipping
spacers and screws from the motor hub.
9. Loosely attach one blade assembly to the motor hub
using the two 1/4-20 x 14 captive screws with
lockwashers. Make sure the screws are NOT
tightened. (Figure 6.) Repeat this procedure for other
four blade assemblies.
3. Ceiling Fan Assembly
(continued)
DOWNROD
PIN
HANGER
BALL
CEILING
COVER
Figure 3
SWITCH HOUSING
MOUNTING PLATE SCREW (4)
Figure 4
#10-24 x 12mm WASHER
HEAD BLADE SCREW (4)
FAN BLADE
Figure 5
SWITCH HOUSING
MOUNTING PLATE HOLE
BLADE FLANGE
ASSEMBLY
Figure 6
6
SETSCREW
COUPLING
COVER
SHIPPING SPACERS
AND SCREWS
FLAT WASHER
16 mm OD
(4 per blade/flange)
BLADE
FLANGE
CAPTIVE SCREW
LOCKWASHER
ETL Model No.: CF921