Table of Contents
Advertisement
owner's manual
700W Marine 5-Channel Amplifier with 2-Way / 3-Way Crossover
Thank you for purchasing a JL Audio amplifier for
your marine sound system.
Your amplifier has been designed and manufactured to exacting
standards in order to ensure years of musical enjoyment in your vessel.
For maximum performance, we highly recommend that you have
your new amplifier installed by an authorized JL Audio dealer. Your
authorized dealer has the training, expertise and installation equipment
to ensure optimum performance from this product. Should you
decide to install the amplifier yourself, please take the time
to read this manual thoroughly so as to familiarize yourself
with its installation requirements and setup procedures.
If you have any questions regarding the instructions in this
manual or any aspect of your amplifier's operation, please contact your
authorized JL Audio dealer for assistance. If you need further assistance,
please call the JL Audio Technical Support Department
at (954) 443-1100 during business hours.
Advertisement
Table of Contents
Related Manuals for JL Audio iM700/5
Summary of Contents for JL Audio iM700/5
- Page 1 For maximum performance, we highly recommend that you have your new amplifier installed by an authorized JL Audio dealer. Your authorized dealer has the training, expertise and installation equipment to ensure optimum performance from this product.
-
Page 2: Protect Your Hearing
The outer shell of your JL Audio amplifier is installed electronic devices. You should also take such high sound pressure levels when connected Do not attempt to “bridge”... -
Page 3: Product Description
While holding the wire in place, tighten the set screw firmly, taking care not to strip the head of the screw. 4 | JL Audio - M700/5 Owner’s Manual... -
Page 4: Turn-On Lead
Appendix A (page 14). filters can be controlled or defeated completely Doing so will result in audible distortion and by way of the three-position “Filter Mode” possible speaker damage. switches in each Channel Section: 6 | JL Audio - M700/5 Owner’s Manual... -
Page 5: Speaker Outputs
To bridge a pair of main channels, use the “Left +” and “Right –” speaker connectors only (the “Left –” and “Right +” remain unused). Each bridged channel pair will deliver optimum power into a 4 ohm load. 8 | JL Audio - M700/5 Owner’s Manual... -
Page 6: Subwoofer Outputs
2.5 mm hex wrench. functioning normally, audio output is active. that it may be sent in to JL Audio for service. are operating in bridged mode, the output will be Strip 1/2 inch (12 mm) of insulation from the There are no user serviceable parts or fuses inside in mono (only one channel). -
Page 7: System Configurations
(6.5-inch or smaller). The sharper tweeters should not be operated with Filter “24dB” setting is typically better when interfacing gradually attenuates frequencies above the selected Frequencies lower than 3 kHz. 12 | JL Audio - M700/5 Owner’s Manual... - Page 8 2Ω 14.1 V not recommended 26.8 V dimensions (lxwxH): 10.23” x 7.09” x 2.05” (260mm x 180mm x 52mm) Due to ongoing product development, all specifications are subject to change without notice. 14 | JL Audio - M700/5 Owner’s Manual...
-
Page 9: Appendix D: Troubleshooting
The speaker wire connectors are designed to accept up to 8 AWG wire. Make sure to strip the wire to allow for a sufficient connection with the metal inside the terminal block. 16 | JL Audio - M700/5 Owner’s Manual... -
Page 10: Installation Notes
Use this diagram to document your amplifier’s switch and control positions. 18 | JL Audio - M700/5 Owner’s Manual... - Page 11 - amPliFiers (usa) JL AUDIO warrants this product to be free of defects in materials and workmanship for a period of two (2) years. This warranty is not transferrable and applies only to the original purchaser from an authorized JL AUDIO dealer.
Need help?
Do you have a question about the iM700/5 and is the answer not in the manual?
Questions and answers