Download  Print this page

GE GSD6900 Owner's Manual page 5

Triton xl
Hide thumbs

Advertisement

Table of Contents
SPEED CYCLE
Heavy 7.8 gal., 37 min.
Medium 6.5 gal., 33 min.
Light 5.2 gal., 29 min.
This cycle is for everyday dishes and glassware.
CHINA CRYSTAL
Heavy 9.1 gal., 52 min.
Medium 7.8 gal., 45 min.
Light 6.5 gal., 38 min.
This cycle is for lightly soiled china and crystal.
GLASSES
Heavy 9.1 gal., 49 min.
(on some models) Medium 7.8 gal., 42 min.
Light 6.5 gal., 40 min.
This cycle is specifically designed for glasses.
RINSE ONLY
Heavy 2.6 gal., 7 min.
Light 1.3 gal., 4 min.
For rinsing partial loads that will be washed later. Do not use detergent with this cycle.
NOTE: This dishwasher is equipped with an ExtraClean
therefore cycle length and time may vary depending on soil and temperature conditions.
NOTE: Only the Anti-Bacteria cycle has been designed to meet the requirements of Section 6, NSF 184 for
soil removal and sanitization efficacy
Enhancements/Extras
4
The light above the selected pad will be ON to indicate which ENHANCEMENT/EXTRA has been selected.
PRE WASH
For use with heavily soiled and/or dried-on, baked-on soils. This option MUST be
(on some models)
selected PRIOR to starting the cycle. This option adds 16 minutes to the cycle time.
NOTE: Cannot be selected with RINSE ONLY cycle.
HEATED DRY
Shuts off the drying heat option. Dishes air dry naturally and energy is saved. For
Light OFF
faster air dry, you can prop the door open after the CLEAN light illuminates.
HEATED DRY
Turns the heater on for fast drying. This will extend the time to your wash cycle by 8
Light ON
minutes for the SPEED CYCLE and 30 minutes for all other cycles. NOTE: Cannot be
selected with RINSE ONLY cycle.
LOCK
You can lock the controls to prevent any selections from being made. Or you can lock
the controls after you have started a cycle.
Children cannot accidentally start dishwasher by touching pads with this option
selected.
To unlock the dishwasher controls, touch and hold the HEATED DRY pad for 3 seconds.
To lock the dishwasher, touch and hold the HEATED DRY pad for 3 seconds. The light
above the LOCK pad will turn off.
ADDED HEAT or
When selected, the cycle will run longer with heating elements on to improve both
EXTRA HOT WASH
wash and dry performance. NOTE: Cannot be selected with RINSE ONLY cycle.
(on some models)
DELAY HOURS
You can delay the start of a wash cycle for up to 9 hours. Touch the DELAY HOURS pad
to choose the number of hours you want to delay the start of the cycle; then touch
START/RESET. The machine will count down and start automatically at the correct time.
Touching START/RESET a second time will cancel the DELAY START selection. NOTE: If
you forget to fully close the door, a reminder signal will beep until you do so.
RESET
To change a cycle after washing starts, touch the START/RESET pad to cancel the
cycle. The START/RESET light will flash while the water is pumped out if needed. This
takes approximately 90 seconds. When the light stops flashing, the dishwasher can be
reprogrammed and restarted.
Sensor with automatic temperature control;
.
ge.com
5

Advertisement

Table of Contents
loading

  Related Manuals for GE GSD6900