Standard Horizon Eclipse DSC+ GX1100E Owner's Manual page 16

KEYPAD
[ ( UP )] / [ ( DOWN )] KEYS
The [ ( UP )] and [ ( DOWN )] keys are used to select a desired chan-
nel and to select items in the DSC OPERATION and SETUP menus.
[ 16/9 ] Key
Immediately recalls channel 16 from any channel location and auto-
matically selects high power. Holding down this key recalls channel 9.
Pressing the [ 16/9 ] key again reverts to the previous selected working
channel.
Secondary use
Press and hold the [ 16/9 ] key then press the [ CLR ] key to switch be-
tween the USA, Canadian, and International Channel Groups.
[ SCAN ( MEM )] Key
Press this key to start and stop the scanning of programmed channels.
Refer to section "8.10 SCANNING" for details.
Secondary use
To add a channel into the scan memory, select the channel and press
and hold the [ SCAN ( MEM )] key until "MEM" is shown on the display.
To delete a memorised channel from scan memory, select the channel
and press and hold the [ SCAN ( MEM )] key until "MEM" is removed from
the display.
[ DISTRESS ] Key
Used to send a DSC Distress Call. To send the distress call refer to section
"9.3.1 (Transmitting A Distress Alert)."
DC INPUT CABLE
Connects the radio to a DC power supply capable of delivering 12V DC.
EXTERNAL SPEAKER CONNECTION CABLE
Connects the GX1100E to an external speaker.
GPS RECEIVER CONNECTION CABLE
Connects the GX1100E to a GPS receiver.
GND TERMINAL
Connects the GX1100E to a good ground, for safety and optimum perfor-
mance.
Install only the supplied screw or similar size ( M3x6, Stainless Steel )
screw.
Page 16 GX1100E