Electrical Connections - Standard Horizon Eclipse DSC+ GX1100E Owner's Manual

6.3 ELECTRICAL CONNECTIONS

Reverse polarity connections will damage the radio!
Connect the power cord and antenna to the radio. Antenna and Power Supply
connections are as follows (see Figure 1):
1. Mount the antenna at least 1 m away from the radio. At the rear of the radio,
connect the antenna cable.
2. Connect the red power wire to a 10.8 VDC ~ 15.6 VDC power source.
Connect the black power wire to a negative ground.
3. If an optional remote extension speaker is to be used, refer to next section
for connections.
4. It is advisable to have a Certified Marine Technician check the power output
and the standing wave ratio of the antenna after installation.
Antenna
Red
Power Source
Fuse ( Q0000127: 6A, 250V ) Replacement
To take out the Fuse from the Fuse Holder, hold
the both ends of the Fuse Holder and pull the Fuse
Holder apart, do not bend the Fuse Holder. When
you replace the Fuse (Q0000127: 6A, 250V), please
confirm that the Fuse is tightly fixed on the metal
contact located inside the Fuse Holder. If the metal
contact holding the fuse is loose, the Fuse holder
may heat up.
Page 10
CAUTION
Optional Speaker
Accessory Cable
Water proof
Deck Outlet
Fuse
Black
Figure 1. General Installation
GPS Navigation Receiver
GX1100E