Set-Up Mode Selection Items - AMT Datasouth Fastmark 4000 Series User Manual

Set-up Mode Selection Items

Item
CUT/PEEL POS (mm)
PRINT OFFSET (mm)
TPH VER OFFS(mm)
RECOVERY PRINT
1
GAP HEIGHT
2
CUTTER ROTATION
2
CUTTER TYPE
COMPRESSED FLASH NO
WIN CON LEN (mm)
BASE SPEED (IPS)
COUNTER ON LCD
MEDIA SENS. TYPE
2
CUTTER SIGNAL
BACKFEED
3
BACK DISTNCE(mm)
1
Displayed only when Switch 4 is on.
2
Displayed only when Switch 3 enabled
3
Displayed only when the BACKFEED feature is enabled.
Range Factory Default
+ 015 to + 015 0 mm
+ 015 to - 008 0 mm
+ 003 to - 003 0 mm
ENABLE ENABLE
DISABLE
MORE THAN 10, MORE THAN 10
5 to 7 mm, mm
8 to 9 mm.
NORMAL (~4"), NORMAL (~4")
MORE (<3"),
MORE (<2")
TYPE I, TYPE I
TYPE II
NO
COMPRESSION, COMPRESSION
COMPRESSED
0 to 254 mm 0 mm
0 to 4 IPS 0 IPS
ENABLED, ENABLED
DISABLED
REFLECTIVE REFLECTIVE
SEE-THROUGH
CHECKED, CHECKED
IGNORED
DISABLE, DISABLE
ENABLE
010 to 040 012
Remarks
Controls cut and peeling position.
Controls start vertical print position.
Positive value only.
2", 3" and 4"(inches) stand for the
label width. Setting proper width can
avoid jam.
Enable the type of cutter mechanism
is installed
This takes effect only when you run
under Windows with bundled printer
driver and use continuous media.
This is for the PPLB emulation only.
When you choose TLP2642/3642
driver the speed is limited under 2
ips.
Select the proper type by the media
characteristics. Do calibration before
printing.
For general media, set it to
"CHECKED" except for thick media.
This feature enables a manual
Present function. It can be disabled
by a software command.
This is the distance the printer will
move the form to a Presentation
position.
User's Guide 41