Jadis I-35 Owner's Manual
  1. Manuals
  2. Brands
  3. Jadis Manuals
  4. Amplifier
  5. I-35
  6. Owner's manual

Jadis I-35 Owner's Manual

Hide thumbs Also See for I-35:

Advertisement

Table of Contents

See also: Owner's Manual
Jadis
I-35
Integrated amplifier
Owner's Manual

Advertisement

Table of Contents
loading

Related Manuals for Jadis I-35

Summary of Contents for Jadis I-35

  • Page 1 Jadis I-35 Integrated amplifier Owner's Manual...
  • Page 2 Table of contents Introduction Warning Unpacking and checking Description Installation instruction Tube position How to match your amplifier to your loudspeaker How to turn ON your amplifier Maintenance I-35 Specifications...
  • Page 3 Introduction Jadis , we are very proud to release a new product after a lengthy period of experimentation and trial. Jadis amplifier is therefore the result of long months of technical research and countless hours of listening. Enjoy your amplifier.
  • Page 4 Warning Read this document thoroughly before any manipulation. Then read step by step when installing.

  • Page 5: Unpacking And Checking

    Unpacking and checking I-35 amplifier has been packed in a box that has been specially designed for it. Do not throw away this box as it will be needed for re-packing the unit when it has to be returned to the factory for maintenance upgrading.

  • Page 6: Front View

    Front View Source Source Source Source Source I-35 Integrated Tube BALANCE On the front side of the integrated, you will find: - The power switch ON/OFF. - The Power led is green when the unit is turned on. - The volume control, it adjusts the sound amplitude.

  • Page 7: Installation Instructions

    Avoid placing objects on top of the amplifier to ensure adequate ventilation. 3 - Because your Jadis is a tube amplifier, provide an open space to allow a correct evacuation of heat. Do not try to cool your Jadis amplifier with a fan or expose it to air currents: sudden cooling create microcracks on the tubes.
  • Page 8 Tubes position IR sensor (if equiped) First of all, remove the grid which protects the tubes sockets (be sure the mains connector is unplugged). Attention: For mounting the tubes, do not force them, this may damage the sockets. Be careful at dressing power tubes (A, B, C and D) because they have stop pins on the central parts of the mounting base.
  • Page 9 How to match your amplifier to your loudspeakers The load impedance is pre-adjusted in the factory for loudspeakers from 4 to 8 ohms. Nota: For a good listening level, choose loudspeakers with an efficiency of more than 90 dB. Internal adjustment of impedance: Warning for connecting the speakers: This equipment reverse the phase.

  • Page 10: How To Turn On Your Amplifier

    How to turn ON your amplifier In order to get the best performance from your Jadis amplifier, it is necessary to follow carefully the instructions below: 1- Check that the power switch is OFF. 2- Verify that the volume control is set to minimum.

  • Page 11: Maintenance

    1 - Turn OFF the unit immediately. 2 - Unplug all the cables. 3 - Do not forget the mains cord. 4 - Contact your Jadis dealer for diagnostic and repair. To clean your amplifier, use a soft cloth with a non abrasive cleaning product.

  • Page 12: Specifications

    I-35 specifications Load impedance: 1 to 16 Ohms Adjustment by internal wiring. Should be done by a qualified technician Output Power at 1kHz: 30 Watts Bandwidth at -3 dB: 20 Hz to 20 kHz Input impedance: > 100k Ohms Input sensitivity for rated output:...

Table of Contents