Table of contents Introduction Warning Unpacking and checking Description Installation instruction Tube position How to match your amplifier to your loudspeaker How to turn ON your amplifier Maintenance JA30 Specifications...
Introduction Jadis , we are very proud to release a new product after a lengthy period of experimentation and trial. Jadis amplifier is therefore the result of long months of technical research and countless hours of listening. Enjoy your amplifier.
Unpacking and checking The JA30 amplifier has been packed in a box that has been specially designed for it. Do not throw away this box as it will be needed for re-packing the unit when it has to be returned to the factory for maintenance or upgrading.
Description Front View On the front side of the amplifier, you will find: - The power switch ON/OFF. - The OPERATE/ STANDBY switch. - The Power led, red when the unit is turned on at stand by state, and green at operate state.
Avoid placing objects on top of the amplifier to ensure adequate ventilation. 3 - Because your Jadis is a tube amplifier, provide an open space to allow a correct evacuation of heat. Do not try to cool your Jadis amplifier with a fan or expose it to air currents: sudden cooling create microcracks on the tubes.
Page 11
Tubes Installation: First of all, remove the grid which protects the tube sockets (be sure the mains connector is unplugged). Attention: For mounting the tubes, do not force them, this may damage the sockets. Be careful at dressing power tubes because they have stop pins on the central parts of the mounting base.
The load impedance is pre-adjusted in the factory for loudspeakers from 4 to 8 ohms. The technical characteristics of the Jadis amplifiers allow an impedance adaptation from 1 to 16 Ohms. Impedance modifications are easily accomplished on the terminal...
How to turn ON your amplifier In order to get the best performance from your Jadis amplifier, it is necessary to follow carefully the instructions below: 1- Check that the power switch is OFF. 2- Check that the OPERATE/STANDBY switch is set to STANDBY.
1 - Turn OFF the unit immediately. 2 - Unplug all the cables. 3 - Do not forget the mains cord. 4 - Contact your Jadis dealer for diagnostic and repair. To clean your amplifier, use a soft cloth with a non abrasive cleaning product.
JA30 specifications Load impedance: 1 to 16 Ohms Output Power at 1kHz: 30 Watts Bandwidth at -3 dB: 20 Hz to 46 kHz Sensitivity for rated output : 500 mV rms. Input impedance: > 100k Ohms Maximum power consumption: 125 W per unit...