Rapid Resume Logic; Troubleshooting - Viper 1002 Installation Manual

Nuisance Prevention
Nuisance Prevention Circuitry bypasses any zone that triggers the system more than three times
®
within a one-hour period. For a full description of NPC
IMPORTANT: When testing the systems sensor and trigger inputs reset NPC
turning on the ignition after every third system trigger.

Rapid Resume Logic

Rapid Resume Logic ensures that when the system is powered up it will return to the same state it
was in when power is disconnected. For a full description of Rapid Resume Logic refer to the
Owner's Guide.

Troubleshooting

Starter kill doesn't work.
Is the correct starter wire being interrupted? If the car starts when the starter kill relay is
➤
completely disconnected, the wrong starter wire has been cut and interrupted. Is the NC/NO
programmed correctly?
YELLOW wire is not connected to true ignition. It is connected to an accessory circuit.
➤
Sensors don't trigger the alarm.
Has the NPC ® ® system been triggered? If so, you will hear five chirps when disarming. To check
➤
this, turn the ignition key on and off to clear the NPC
sensors. For a detailed description of NPC
Door input does not immediately trigger full alarm. Instead, I hear chirps for the first three seconds.
That's how the progressive two-stage door input works! This is the instant response feature of
➤
this system. Even if the door is closed immediately, the system provides an instant trigger by
chirping, and then progressing to a constant siren.
40
® Circuitry
® operations refer to the Owner's Guide.
from memory, and then retest the
® ®
, see Owner's Guide.
® ®
® by
© 2006
Directed Electronics