Operating Instructions; Setup; Setting Up The System; Lcd Menu Navigation - Blizzard Lighting PROKONTROL MH User Manual

3. OPERATING INSTRUCTIONS

3.1

Setup

3.1.1 Setting Up The System

Plug the AC to DC power supply to the system back panel and to the mains
outlet.
Plug in your DMX cable(s) to your intelligent lighting as described in the fixtures
respective manual. For a quick lesson on DMX see the DMX Primer section in
the Appendix of this manual.

3.2 LCD Menu Navigation

Press and hold the <MENUS> button for 2 seconds to enter/exit Menu Mode.
The menu options are as follows:
01. Patch Fixture - To patch fixtures starting addresses and the
channel position, etc.
02. Reset Factory - To restore the factory settings.
03. Delete All Fixture Patch - To delete all patch settings.
04. Fade Mode - To set fade time mode.
05. RDM DMX Address Setup - To implement RDM functions.
06. Data Back Up - To back up data to a USB memory stick.
07. Data Load - To load data from a USB memory stick.
08. Send Fixture Update File - To send the fixture update code.
The PAN wheel is used to browse between the menu options.
ProKontrol MH Manual Rev. A
Page 8
© 2013 Blizzard Lighting, LLC