Fixture Patching Instructions (Step By Step) - Blizzard Lighting PROKONTROL MH User Manual

3.4. Fixture Patching Instructions (Step by step)

Follow these steps to begin patching your fixtures:
1. Press and hold <MENUS> for 2 seconds to enter Menu Mode.
2. Rotate the PAN wheel to locate:
3. Press <ENTER> to confirm.
4. Select a fixture (only one fixture can be selected).
Press <SWAP> to switch between the four settings:
5.
aDDreSS, FaDer ChaNL, FaDer reVerSe
6. In
start address; press <ENTER> to save, or press <DEL> to delete
the existing DMX start address.
7. In
within "1/R" to "TILT". Rotate the TILT wheel to adjust the address
of the corresponding DMX channel within 1-40. Press <ENTER> to
save the patching or press <DEL> to delete the existing patching.
8. In
within "1/R" to "TILT". Rotate the TILT wheel to select YES or NO;
YES means to set the corresponding channel reverse; NO means
inverse. Press <ENTER> to save the setting.
9. In
the fixture's color channels. Rotate the PAN wheel, select YES or
NO; YES means to enable; NO means to disable. Press <ENTER>
to save the settings.
10. To copy a patched fixture to a new fixture, press and hold the
number button of the patched fixture, then press the number
button of a new fixture.
11. Press <ESC> to exit patch setting.
*DMX START ADDRESS + FADER CHANNEL, - 1 = FADER DMX ADDRESS
Example: If FIXTURE 1 is set to 11 as its DMX starting address, and its 1/R
fader channel is set to 1, when you move the 1st fader the output of the 11th
DMX channel will be changed.
But, if FIXTURE 1 is set to 11 as its DMX starting address, and its 1/R fader
channel is set to 10, and you move the 1st fader, the output of the 20th DMX
channel will be changed.
When patching, a "!" mark will be shown in the LCD display when there is
a overlap in the patching of DMX channels. This will need to be corrected,
otherwise the DMX output may run in error.
ProKontrol MH Manual Rev. A
DMx Start aDDreSS
FaDer ChaNL
, rotate the PAN wheel to select a fader name
FaDer reVerSe
COLOr FaDe
, you can enable or disable the fade in/out time of
01. PatCh Fixture.
, rotate the PAN wheel to adjust the DMX
, rotate the PAN wheel to select a fader name
Page 10
DMx Start
COLOr FaDe
and .
© 2013 Blizzard Lighting, LLC