Basic Commands (Direct Access); Arm; Disarm - Viper 3606V Owner's Manual

Basic Commands (Direct Access)

Arm

Press and release
The alarm arms, doors lock (if connected), and the siren chirps and
parking lights flash once. If Valet mode* is On, the doors lock without
siren chirps, the alarm is disabled. Exit Valet mode to arm the alarm
normally.
If a trigger zone fault is detected the siren chirps once again and the
control center LED generates a Trigger Zone Fault report**.
To Arm and Panic
Press and hold
The alarm Arms (or Locks in Valet) and, after two seconds, sounds
the siren and flashes the parking lights. Press the
to stop the output.

Disarm

Press and release
The alarm disarms, doors unlock (if connected), and the siren chirps
and parking lights flash twice.
An Alarm Report** alert of four or five siren chirps will replace the
normal disarm chirps if the alarm was triggered.
© 2013 Directed. All rights reserved.
or button
7