Lubrication; Lubrication Schedule; General - Husqvarna ZTH Operator's Manual

Lubrication

Lubrication Schedule

( )
Lubrication schedule

General

Remove the ignition key to prevent unintentional movements during lubrication.
When lubricating with an oilcan, it ought to be filled with engine oil.
When lubricating with grease, unless otherwise stated, grease 503 98 96-01 or another chassis or ball
bearing grease offering good corrosion protection shall be used.
For daily use, the machine shall be lubricated twice weekly.
Wipe away excess grease after lubrication.
It is important to avoid getting lubricant on the belts or the drive surfaces on the belt pulleys. Should this
happen, attempt to clean them with spirits. If the belt continues to slip after cleaning with spirits, it must be
replaced. Gasoline or other petroleum products must not be used to clean belts.
LUBRICATION
(2x)
(2x)
(2x)
(2x)
(2x)
8011-620
English-
33