Preparing The Outer Door; Mount Plate - AEG Favorit 45250Vi Instruction Booklet

en ru AEG F45250Vi 2-11-01 15.05
Position- and connection instructions

Preparing the outer door

Screw the guide rods and hinges on the
door into place using the predrilled holes.

Mount plate

Before installing the dishwasher and
adjusting the door onto the cupboard, put
the mount plate into its correct position on
the shelf.
1. Place the mount plate in the middle
of the cupboard. Mark the holes
for screws and the holes for dis-
mounting the outer door. There is
a middle mark on the plate to
help you.
2. Drill 4 holes with a diameter of
7 mm. The door can be discon-
nected if necessary, through hole
1 (two holes).
3. Then screw the plate into place
from underneath using the 2 screws
provided, with the washers bet-
ween.
4. Snap the hinges into the brackets
on the mount plate.
The outer door should be supported
underneath in order to prevent the
hinges from breaking off.
5. Adjust the door to surrounding
doors using screws A, B and C.
30
Sidan 30
1
A B
2x
4x
1
C C