Cleaning The Appliance; Appliances With Stainless Steel Outer Surfaces - AEG ÖKO−FAVORIT 55750 Instructions For Use Manual

Central spray arm
1. Remove the central spray arm by turning it to the
side, and hoisting off.
The two−part spray arm bearing is held together by
a clamping spring (B).
2. To re−install, press the central spray arm upwards
until you can feel it locking into place.
Lower spray arm
Remove the lower spray arm:
1. Loosen the nut (C) by turning it to the left
2. Pull the spray arm from the shaft
3. Clean the nozzles
4. Refix the spray arm with the nut (C) by turning to
the right.
Shake stubborn waste out of the spray arm af−
ter allowing it to dry completely.

Cleaning the appliance

Clean the outer surfaces of the machine, and in parti−
cular the control panel, regularly using a soft, damp
cloth.
Only use neutral detergents (e.g., hand washing liquid),
but not scouring agents or solvents such as acetone,
paintbrush cleaner or thinners etc.
Appliances with stainless steel
outer surfaces
For the stainless steel front, we recommend thorough
and regular care and cleaning with suitable stainless
steel cleaners.
Pay attention to the instructions regarding detergents
and care products. Do not use abrasive or scouring
agents.
Before wiping, apply the detergent to a damp cloth,
clean the surfaces with it, and dry with a clean cloth.
When cleaning, ensure that the stainless steel surface
finish (the fine diagonal lines) is not worked against
the grain: no circular movements!
22
B
C