Advertisement
Troubleshooting & Technical Specifications
Problem: I'm only see a blank screen where I want to see my images.
Solutions:
1.
Make sure that both the camera and the receiver are receiving power from their supplied power
adapters.
2.
Ensure that the camera is properly paired with the receiver by following the instructions on page 5.
3.
Check that the channel you are displaying is the one paired with the camera. Try turning other
channels off.
4.
If all else fails, try moving the camera closer to the receiver, and be sure there are no obstacles
(such as thick walls or metal sheets) in between the camera and the receiver blocking the
signal.
Problem: When I view the footage from the camera at night, I see a bright white spot and no
image.
Solution: Having the camera looking out a window is problematic, as the glass will refl ect the
infrared beams from the LEDs, over-exposing your image. Move the camera so that there are no
barriers (even transparent barriers such as glass) between the camera and what you want to see.
Also, make sure there are no objects within 3'/1m of the lens, as these can refl ect the infrared beams
as well.
Problem: The image on my TV appears to be distorted.
Solution: Check the PAL/NTSC settings on your television are correct for your region (NTSC for
USA and Canada, PAL for Australia and Western Europe). If this does not fi x the problem, check the
connections between the receiver and your screen. If you are using a long RCA cable (anything over
6'/2m) try using a shorter one, particularly if there are other electrical devices located close to the
TV and receiver.
Problem: At night, the camera can only see 26'/8m.
Solution: This is not a malfunction – this is the range of the infrared beam that the camera uses to
see at night. Move the camera closer to what you wish to view. Alternately, you could purchase and
install a sensor fl oodlight, which are available at most good hardware stores.
Technical Specifi cations: ADW-200
Video
Image Sensor
Video Quality
Number of Effective Pixels
Minimum Illumination
Day/Night Mode
White Balance
Signal / Noise Ratio
Electronic Shutter
NTSC, 1/50 - 15, 000 PAL
Gain Control
Backlight Compensation
Wide Dynamic Range
Lens
Viewing Angle
Audio
Microphone
Audio Range
Night Vision Distance
IR Cut Filter
1/4" CMOS
Number of Infra-Red LEDs
380 TV Lines
Infra-Red LED Life
640 x 480
0 Lux (IR On)
Color during day /
Indoor / Outdoor
switches to B&W
Operating Power
at night
Operating Temperature
Automatic
-20°C ~ 50°C
< 48dB
Body Construction
1/60 - 1/15, 000
Dimensions - Camera & Stand
Automatic
Yes
No
6mm
Digital or Analog
53 degrees
Max. Transmission Range
Typical Range
Frequency
Yes
Transmission Channels
9ft / 3m
Night Vision
Up to 26ft / 8m
No
27
10, 000 hours
General
Both
DC 5V
-4°F ~ 122°F /
Aluminium
5.1" x 3.7" x
2.4" / 130mm x
95mm x 60mm
Wireless
Digital
Up to 165ft / 50m
65ft / 20m
2.4 GHz (FHSS)
4
7
Advertisement
