FMI G36 Owner's Operation And Installation Manual

FMI G36 Owner's Operation And Installation Manual

36" wood burning masonry fireplace

Advertisement

36" Wood Burning Masonry Fireplace
oWner's operaTion and insTallaTion Manual
PFS
®
C
US
ICC-ES #ESR-2542
(V)G36 - Smooth Face with Insulation
(V)G36R - Smooth Face with Insulation and Bottom Door Rail
(V)G36H - Smooth Face with Insulation and Herringbone Refractory
(V)G36HR - Smooth Face with Insulation, Bottom Door Rail
and Herringbone Refractory
SAVE THIS BOOK
This book is valuable. In addition to instructing you
on how to install and maintain your appliance, it also
contains information that will enable you to obtain re-
placement parts or accessory items when needed. Keep
it with your other important papers.
This fireplace is approved for use as a wood burning
fireplace or for use with a vented gas log approved
to ANS Z21.60, Z21.84 standards or for use with a
vent-free gas log heater approved to ANS Z21.11.2
standard.
This wood burning fireplace complies with UL127-
CAN/ULS-S610-M87 standard as a FACTORY BUILT
APPLIANCE.
FOR CANADA: The authority having jurisdiction (such
as the municipal building department, fire department,
etc.) should be contacted before installation to deter-
mine the need to obtain a permit.
INSTALLER: Leave this manual with the appliance.
CONSUMER: Retain this manual for future reference.
For more information, visit www.fmiproducts.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the G36 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for FMI G36

  • Page 1 Manual ® ICC-ES #ESR-2542 (V)G36 - Smooth Face with Insulation (V)G36R - Smooth Face with Insulation and Bottom Door Rail (V)G36H - Smooth Face with Insulation and Herringbone Refractory (V)G36HR - Smooth Face with Insulation, Bottom Door Rail...
  • Page 2: Table Of Contents

    • The FMI PRODUCTS, LLC warranty will out of traffic and away from be voided by and FMI PRODUCTS, LLC furniture and draperies. disclaims any responsibility for the follow- • Do not place clothing or other ing actions.
  • Page 3: Specifications

    saFeTy Continued WARNING: Always leave glass doors fully opened or fully closed when operating fireplace. speciFicaTions ROUND TOP TERMINATION SQUARE CHASE-TOP TERMINATION 1" CHIMNEY AIRSPACE CLEARANCE TO COMBUSTIBLE MATERIAL NO COMBUSTIBLE MATERIAL ON FACE COMBUSTIBLE WALL BOARD " AIR SPACE BACK AND SIDES OUTSIDE AIR MINIMUM 12"...
  • Page 4: Fireplace Installation

    Fireplace insTallaTion SELECTING LOCATION FRAMING To determine the safest and most efficient 1. Frame opening for fireplace using dimen- location for the fireplace, you must take into sions shown in Figures 1 and 2. consideration the following guidelines: 2. If fireplace is to be installed directly on 1.
  • Page 5 Fireplace insTallaTion Continued HEARTH ExTENSION MANTELS A hearth extension projecting a minimum of A mantel may be installed if desired (see Figure 20" in front of and a minimum of 12" beyond 4). Woodwork such as wood trims, mantels or each side of fireplace opening is required to any other combustible material projecting from protect combustible floor construction in front...
  • Page 6: Venting Installation

    DOUBLE WALL CHIMNEY SYSTEM CHIMNEY PIPE Each double wall chimney section consists of The FMI PRODUCTS, LLC chimney system a galvanized outer pipe, a stainless steel in- consists of 12", 18", 24", 36" and 48" snap- ner flue pipe and a wire spacer. Pipe sections...
  • Page 7 VenTing insTallaTion Continued USING ELBOW OFFSETS (30E-12DM) Continue to assemble chimney sections as outlined above, making sure that both inner 1. To achieve desired offset, you may install and outer pipe sections are locked together. combinations of 12", 18", 24", 36" and 48" When installing double wall snap-lock chim- length of double wall pipe (see offset chart ney together, it is important to assure the joint...
  • Page 8 VenTing insTallaTion Continued Return Return Elbow Elbow Return Offset Offset Elbow Elbow Elbow 6' Max. 6' Max. Ceiling Support Pipe Return 12S-12DM 6' Max. Return Elbow Elbow 6' Max. Offset Offset Elbow 6' Max. Elbow 6' Max. Offset Elbow Figure 9 - Typical Offset Terminations Screws or Staples FIRESTOP SPACERS (1100EFS-10DM) Firestop...
  • Page 9 VenTing insTallaTion Continued 5. Add next sections of pipe until the end pen- Installing Flashing on a Metal Roof etrates the roof line. Check to see that the When installing flashing on a metal roof, it proper clearances are maintained. Extend is required that putty tape be used between chimney by adding sections of double wall flashing and roof.
  • Page 10: Optional Gas Line Installation

    VenTing insTallaTion Continued 10 FOOT RULE CAUTION: Do not seal open- All flue gas outlet chimney terminations must ings on the rooftop flashing. Fol- extend a minimum of 3 feet in height above the low the installation instructions highest point where it passes through the roof and must be at least 2 feet above the high- provided with the termination est point of the roof that is within a horizontal...
  • Page 11 opTional gas line insTallaTion Continued 2. Remove gas line cover plate located on WARNING: Do not oper- either side of fireplace and pull out insu- lation from gas line conduit sleeve. Save ate an unvented gas log set in insulation for reuse. Replace screws. this fireplace with the chimney 3.
  • Page 12: Glass Door Installation

    glass door insTallaTion INSTALLING GLASS DOORS IMPORTANT: Install glass door Spring clips have been installed but some frame before installing glass adjustments may be needed. If doors do not door. close properly or do not appear straight, see Door Adjustment. INSTALLING DOOR FRAMES 1.
  • Page 13: Operation And Maintenance Guidelines

    WARNING: Risk of fire! Re- risks of both fire and smoke. place grate with FMI PRODUCTS, LLC model 109496-03 grate only. This grate has been designed to keep the operation of your fireplace safe and efficient.
  • Page 14: Replacement Parts

    Bottom Front Brick Refractory Bottom Front Brick Refractory 116092-01 - VG36H Models 116091-01 - VG36 Models 116092-02 - G36H Models 116091-02 - G36 Models Bottom Rear Brick Refractory Bottom Rear Brick Refractory 116089-01 - VG36H Models 116084-01 - VG36 Models...
  • Page 15: Technical Service

    Technical serVice Continued You may have further questions about installation, operation, or troubleshooting. If so, contact FMI PRODUCTS, LLC at 1-866-328-4537. When calling please have your model and serial numbers of your heater ready. Model and serial number information are in the fireplace's rating plate located in the fireplace bottom.
  • Page 16 accessories Continued FIRESTOP SPACER - 1100EFS-10DM SQUARE CHASE-TOP TERMINATION - STL-12D ROOF FLASHING V6F-10DM - 0 to 6/12 Pitch V12F-10DM - 6/12 to 12/12 Pitch ROUND TOP TERMINATIONS RLT-12D AND RLT-12HT 2701 S. Harbor Blvd. Santa Ana, CA 92704 116010-01 1-866-328-4537 Rev.

This manual is also suitable for:

G36rG36hG36hrVg36Vg36rVg36h ... Show all

Table of Contents