Listening To The Radio; Fm Stereo Mode Indicator; Fm Stereo Receiving Indicator - Sharp XL-UH4H Operation Manual

Listening to the radio

Tuning
1
Press the ON/STAND-BY button to turn the power on.
2
Press the TUNER (BAND) button repeatedly to select the
desired frequency band (FM or AM).
3
Press the TUNING/FOLDER (
the desired station.
Manual tuning:
Press the TUNING/FOLDER (
as required to tune in to the desired station.
Auto tuning:
When the TUNING/FOLDER (
more than 0.5 seconds, scanning will start automatically and
the tuner will stop at the first receivable broadcast station.
or ) button to tune in to
or ) button as many times
or ) button is pressed for
Notes:
When radio interference occurs, auto scan tuning may stop
automatically at that point.
Auto scan tuning will skip weak signal stations.
To stop the auto tuning, press the TUNING/FOLDER (
button again.
When an RDS (Radio Data System) station is tuned in, the fre-
quency will be displayed first, and then the RDS indicator will light
up. Finally, the station name will appear.
Full auto tuning can be achieved for RDS stations "ASPM", see
page 30.
To receive an FM stereo transmission:
Press the TUNER (BAND) button to display the "ST" indicator.
" " will appear when an FM broadcast is in stereo.
If the FM reception is weak, press the TUNER (BAND) button to
extinguish the "ST" indicator. The reception changes to monaural,
and the sound becomes clearer.
Memorising a station
Up to 20 station for FM band, 10 station for AM band can be store
and recall them at the push of a button. (PRESET (
1
Perform steps 1 - 3 in "Tuning" on page 29.
2
Press the MEMORY/DISP button to enter the preset tuning
saving mode.
or

FM stereo receiving indicator

MHz
ST

FM stereo mode indicator

or ) )
Continued to the next page
XL-UH4H
)
29