Parts Identification; Front; Rear - Sony Power HADFX HDC-P1 Operation Manual

Parts Identification

Front

1
2
3
4
5 6
a Front tally lamp
The tally lamp lights when a call signal is generated in
response to the pressing of a CALL button or a tally signal
input to the EXT I/O connector.
You can attach the supplied number plate to display the
camera number.
Note
The front tally function cannot be operated during a battery
alarm operation.
b LENS connector (12-pin)
Connect the cable of the lens. The camera can control the lens
functions through this cable.
Connect the lens cable so that v is at the top.
c Lens cable clamp
To secure the cable of the lens (optional).
d Lens mount safety rubber
After attaching a lens, attach the rubber to prevent the lens
from coming loose.
Before removing the lens, remove this rubber from the boss on
the front panel.
e Lens mount cap
The cap can be removed by moving the lens fixing lever
upward.
Always keep the lens mount covered with this cap when a lens
is not attached.
f Lens fixing lever
Move the lever down to secure the lens in the lens mount.
g CC filter select knob
To select the built-in CC filters (A: cross, B: 3200K, C: 4300K,
D: 6300K).
h ND filter select knob
To select the built-in ND filters (1: clear, 2: 1/4 ND, 3: 1/16 ND,
4: 1/64 ND).
8
Overview

Rear

1
2
3
4
7
5
8
6
7 8 9
a Rear tally lamp
The tally lamp lights when a call signal is generated in
response to the pressing of a CALL button or a tally signal
input to the EXT I/O connector.
The rear tally lamp also serves as a battery alarm function.
If the voltage of the battery connected to the camera
decreases, the rear tally lamp flashes, and if the limit becomes
close to being reached, the rear tally lamp switches to high-
speed flashing.
The alarm voltage for starting flashing can be set in the
BEFORE END item of the BATTERY ALARM page on the
MAINTENANCE menu, and the alarm voltage for switching to
high-high speed flashing can be set in the END item.
If a call signal is generated while the battery alarm function is
operating, the rear tally lamp goes out. Furthermore, the front
tally function becomes inoperable, so replace the battery.
If you want to give priority to the tally function and call function,
set the BATTERY ALARM item of the BATTERY ALARM page
on the MAINTENANCE menu to OFF.
For details, see "MAINTENANCE Menu" (page 24).
b DISPLAY/MENU switch
Select the display on the monitor screen.
DISPLAY: To display various textual information and markers,
such as messages showing the camera settings and
operating status, the center marker, and the safety zone
marker, in addition to camera images.
(OFF): To not display textual information and markers.
z
MENU: To display menus for camera settings, in addition to
camera images.
c Menu control knob (rotary encoder)
Used to select settings from menus displayed on the monitor
screen (by rotating it) and to confirm settings (by pushing it).
d EXT I/O (external input/output) connector (D-sub, 15-
pin)
Connect an external device.
0
qa
qs
qd
qf