D-Link DES-6000 User Manual page 77

Select the desired device in the Switch field and the desired increment setting in the Update Interval field: 5
sec, 15 sec, 30 sec, 1 min, or Suspend.
The statistic counters displayed are defined as follows:
♦ Update Interval 5 sec, 15 sec, 30 sec, 1 min, or Suspend. The setting causes the switch to sample the wire
at the interval chosen.
♦ TX/sec The number of good bytes sent from the respective port per second.
♦ RX/sec The number of good bytes received per second. This also includes local and dropped packets.
♦ %Util. This shows the percentage of available bandwidth each port is using during a single second at the
time specified by the update interval. The utilization percentage is the total number of bits transmitted
and received on the port per second divided by the bandwidth per second. Please note that bandwidth
values are doubled for full-duplex connections (i.e. 100BASE-TX at full duplex is 200Mbps).
Port Traffic Statistics
To access the second item on the Traffic Statistics menu, choose Port Traffic Statistics. The following
table appears:
Select the desired module in the Module field, the desired port range in the Ports field, and the desired
increment setting in the Update Interval field: 5 sec, 15 sec, 30 sec, 1 min, or Suspend.
Using the Console Interface
Figure 6-49. Port Utilization screen
Figure 6-50. Port Traffic Statistics screen
Modular Ethernet Switch User's Guide
67