Rear Panel Connections - Cambridge Audio Topaz AM10 User Manual

Rear panel connections

1
MP3 / Aux CD Tuner / DAB
Audio inputs
1
These inputs are suitable for any 'line level' source equipment such as the
audio outputs of CD players, BD/DVD players, etc.
2 Phono input
This input has a built in phono stage. Record players fitted with Phono
Cartridges of the Moving Magnet (MM) or h h igh output Moving Coil (MC)
type (between 2-6mV output and 30-50k load impedance) can be used.
Low output Moving Coil types (<1mV and usually 10-1000 ohm load
impedance) cannot be directly connected and will require a matching
transformer or head amp. Please consult your dealer for details.
Note: The 'Ground' terminals on both the record player and the AM10
should be connected (where possible) with a ground wire for lowest
noise/hum pickup.
Rec Out
3
Connect to the recording input of a tape deck, CD recorder input, etc.
Loudspeaker terminals
4
Connect the wires from your left channel loudspeaker to the Left positive
and negative terminals, and the wires from the right channel loudspeaker
to the Right positive and negative terminals. In each case, the red terminal
is the positive output and the black terminal is the negative output.
Care should be taken to ensure no stray strands of wire are shorting
speaker outputs together. Please ensure that the loudspeaker terminals
have been tightened adequately to provide a good electrical connection.
It is possible for the sound quality to be affected if the screw terminals are
loose.
5 Voltage select switch
For servicing use only.
6 AC power socket
Once all connections are complete, plug the AC power cable into an
appropriate mains socket and turn the unit on.
Ground
Left
Right
Right
Phono BD / DVD Rec Out
Loudspeaker Terminals
Impedance 4–8 ohms
2 3 4
Designed and engineered in London, England
Topaz AM10 Integrated Amplifier
5
Left
Mains Voltage Selector Switch 115V/220-230V AC ~ 50/60Hz
Rated Power Consumption: 260W
AM10
Power AC
6
5