Record Setup - Swann DVR4-Net Installation Manual

10. Record Setup

When the cursor moves to Record Setup, then push enter button, the Record Setup window
will appear, which is illustrated as below. Push up or down button to move the cursor. Push
" "or " " button to change the value. While the DVR is in recording or playback mode, you + -
cannot access to this menu unless you stop record or play first.
OVER WRITE: if set to " YES ", the DVR will automatically overwrite the HDD from the
beginning when the HDD is full. If set to "
when the HDD is full.
REC SPEED: the recording frame rate of the DVR, factory default setting is
NTSC 25F/1SEC for PAL ( ), Which means DVR records the events at the speed of 30 shots
of frames per second. The higher the record frame rate, the more natural look will be
displayed on the screen when you playback. The lower the record frame rate, the more you
can save the space on the hard disk drive. The highest frame rate is
50F/1SEC ).
REC QUALITY: There are four different video quality settings:
VERY HIGH . The higher the video quality, the clearer images when you playback. The lower
the video quality, the more you can save the space on the hard disk drive.
RESOLUTION: the record picture size of the DVR, there are two modes:
720 ,default is 360 . In 720 mode, the record picture is twice bigger than in
360 mode can save half of HDD usage.
PB SPEED: the frame rate of playback, default is
AUDIO ENABLE: audio select, the DVR has one record channel, you can select one in four
channels, the default is channel one.
A/M REC TIME: when a motion or sensor alarm occurs, this option sets the DVR recording
duration, the default is one minute.
9
NO ", the DVR will automatically stop recording
30F/1SEC for
60F/1SEC PAL - (
LOW NORMAL HIGH , ,
360 and
360 mode, but in
NO USE , which means the same as record.
Enter the correct IP address
enter the IP address of your Broadband Modem or Router
according to the TV system in your location, then click "OK". When users survey by Internet,
To view the DVR4Net from the Internet you should first enable
called Virtual Server
address assigned to the DVR4Net. Consult the manual of your Broadband Modem or Router
for information on how to do this.
Once the correct settings are made and you have entered the correct details you will see the
window below.
1
5 6 7 8
and
The various software buttons of the remote viewing software are detailed below.
- 1. Live: if you select this, you can connect to the DVR from the Internet and view live
pictures on the DVR.
- 2. Net Search: if you select this, you can search the video recorded on HDD of the DVR,
- 3. Local Search: if you select this, you can play the video recorded on you computer.
- 4. HDD Scan: it can scan all video information on a HDD that has been used on a DVR.
- 5. Connect button:
- 6. Disconnect button:
- 7. Local record button:
computers HDD.
- 8. Setting: click to display the settings window.
Live Operation: if the software is in live mode (click
DVR, and the live pictures will be transmitted to display on the window. Click
transmitting picture.
of the DVR4Net (if connecting over the Internet you will need to
) and select PAL or NTSC
) on ports 5000-5002 on your router and forward these ports to the IP
2 3 4
begin connection with DVR4Net
disconnect from DVR4Net
Click on this icon,to record the pictures from the DVR to your local
), then click
Port Forwarding (sometimes
, it will connect to the
, to stop
30