Assembly - Vermont Castings Defiant 1945CE Homeowner's Installation And Operating Manual

Defiant Woodburning Stove
Set Up Your Stove
Cast iron stoves are heavy, and it will take two to four
people to move your Defiant into position.
Wipe the protective coating of oil from the griddle with a
clean dry rag or a paper towel.
Install the handle on the griddle. Slip the bolt through a
washer, a nylon bushing, then through the handle and
the other bushing, then through the steel spacer and
into the griddle tab. (Fig. 13) Tighten securely.
Bushings
Fig. 13 Attach the griddle handle.
ST536
Install Stove Legs
Attach
The stove is shipped with the legs attached. In some
griddle handle
instances, the legs may have been removed. Fol-
11/00
low these instructions to reattach the legs. Install the
stove legs (Fig. 21) using the hex head bolts from the
parts bag. Use 3/8" washers with all four legs; the door
handle holder installs on the right front leg. Position the
holder so the hole to accept the handle hub faces out
from the right side of the stove. Tighten the bolts firmly.
CAUTION: Overtightening can strip tapped threads.
NOTE: When moving the stove, lift the stove to take
weight off the legs whenever possible. Dragging or
sliding the stove, especially across rough surfaces can
cause the legs to loosen or even break.
Fig. 14 Attach the stove legs.
12

Assembly

Spacer
Knob
Washer
Bolt
ST536
Leg Bolt
and
Washer
ST858
�����
������ ����
�����
Storing the Handle
Use the removable handle to open or close the doors.
After using it, remove the handle so it will not get hot.
Store the handle in the handle holder installed behind
the right front leg. (Fig. 15)
Leg Bolt and Washer
Fig. 15 Handle holder and heat shield positions.
Install the Optional Bottom Heat Shield
NOTE: The Bottom Heat Shield is required in most
installations. Refer to Floor Protection, Page 10, for
further details.
1. Remove the four 10-24 x 1/2" hex head bolts from
the corners of the ash drop on the stove bottom.
a n t
D e f i
2. Screw the four 1¹⁄₄" spacers into the holes from
which you removed the bolts, finger-tight.
3. Align the bottom heat shield against the spacers with
the stepped side toward the rear of the stove.
4. Secure the shield with the four hex head bolts
removed from the stove bottom previously. Tighten
securely. (Fig. 16)
Spacers
Fig. 16 Attach the optional bottom heat shield.
ST537
Attach
Bottom Heat
Shield
11/00
Bottom Heat Shield
Door Handle Holder
ST564
handle holder
12/13/00
30003841
ST564
ST537