Table of Contents
Advertisement
Top of form
When you power on the printer, the top-of-form position is automati-
cally set to the current position. If this is not where you want the top of
the page to be, you can change the top-of-form position as follows:
1. Press the
2. Move the paper to the desired top-of-form position by pressing the
button.
3. Press and hold the
4. While holding the
then release both buttons at the same time. The top-of-form posi-
tion has been set.
Forward micro-feed
For fine alignment, you can feed the paper forward in very small incre-
ments as follows:
1. Press the
2. Press the
3. While holding the
ton. The paper will start advancing in a series of small steps.
When you want to stop, release both buttons.
Reverse micro-feed
You can also feed the paper in small increments in reverse, to return to
a higher position on the same page.
1. Press the
2. Press the
3. While holding the
The paper will start moving backwards in a series of small steps.
When you want to stop, release both buttons.
NOTE
Open the bail lever when the printer beeps intermittently near the edge of
the paper.
button to set the printer off-line.
button.
button down, press the
button to set the printer off-line.
button again and hold it down.
button down, press the
button to set the printer off-line.
button again and hold it down.
button down, press the
button,
but-
button.
31
Advertisement
Table of Contents
