Removal And Replacement - GE Profile JGP656 Series Technical Service Manual

Burner Cap
Burner Head
Burner Bowl
Cooktop Cooktop
Recess Ring Recess Ring
Manifold Manifold
Gas Line Gas Line
Gas Line Gas Line
Fitting Fitting
Fitting Fitting
Screw Screw

Removal and Replacement

Burner Grate
GEA00249
Ignitor Ignitor
Retainer Retainer
Ring Ring
3 Nuts 3 Nuts
and Washers and Washers
Venturi Venturi
Assembly Assembly
3 Nuts, Washers, 3 Nuts, Washers,
and Felt Washers and Felt Washers
GEA00314
Screw Screw
GEA00315
WARNING: Disconnect electrical power to the
cooktop and turn OFF gas at the main valve before
performing any removal procedures.
Remove Venturi Assembly and Burner Bowl
1. Remove burner grate, burner cap, and burner head
from cooktop.
2. From below cooktop, remove 17 screws and bottom
pan.
3. From below cooktop, remove retainer ring and igniter
from burner bowl.
4. Remove 1/2-in. nut and gas line from venturi
assembly.
5. Remove three 7-mm nuts, 3 washers, and venturi
assembly from burner bowl.
6. Remove three 7-mm nuts, washers, felt washers, and
cooktop recess ring from burner bowl.
7. Remove burner bowl.
Remove Gas Valve Assembly
1. Remove 4 (or 5) gas control knobs.
2. From below cooktop, remove 17 screws and bottom
pan.
3. Remove 4 (or 5) gas line fittings.
4. Remove manifold gas line fitting from regulator.
Caution: When assembling the following, replace with
the exact screws to prevent glass breakage.
5. Remove 2 screws and manifold from cooktop.
6. Remove 1/4-in. screw and gas valve from manifold.
– 26 –