AIR FLOW DIRECTION ADJUST
Press the AIR FLOW DIRECTION button to adjust
the air fl ow angle.
Up and down adjustment
•
The movable limit of the fl ap is changeable.
Contact your dealer for details.
Press the AIR FLOW DIRECTION ADJUST
button to select the air direction as shown
below.
The AIR FLOW FLAP display
swings as shown below and the
air fl ow direction continuously
varies. (Automatic swing setting)
swing
Press AIR FLOW DIRECTION
ADJUST button to select the air
direction of your choice.
The AIR FLOW FLAP display
stops swinging and the air fl ow
direction is fi xed (Fixed air fl ow
direction setting).
MOVEMENT OF THE AIR FLOW FLAP
For the following conditions, micro computer con-
trols the air fl ow direction so it may be different
from the display.
Operation
Cooling
mode
•
When room
temperature is
lower than the
Operation
set temperature
condition
•
When operating
continuously at
horizontal air
fl ow direction
Operation mode includes automatic operation.
7
Operate in the following order.
Press the TIMER MODE START/STOP
button several times and select the mode
on the display.
The display fl ashes.
For setting the timer stop .... "
For setting the timer start .... "
Press the PROGRAMMING TIME button and
set the time for stopping or starting the
system.
Heating
Press the TIMER ON/OFF button.
•
When room
The timer setting procedure ends.
temperature is
The display "
higher than the
ing light to a constant light.
set temperature
•
At defrost opera-
tion
PROGRAM TIMER OPERATION
•
The timer is operated in the following two ways.
•
Programming the stop time (
system stops
operating after the set time has elapsed.
•
Programming the start time (
tem starts
operating after the set time has elapsed.
•
The timer can be programmed a maximum of
72 hours.
•
The start and the stop time can be simultane-
ously programmed.
1
TIMER MODE START/STOP
2
PROGRAMMING TIME
When this button is pressed, the time
advances by 1 hour.
When this button is pressed, the time
goes backward by 1 hour.
3
TIMER ON/OFF
or
Refer to fi gure 4 on page [1]
NOTE
•
When setting the timer Off and On at the same
time, repeat the above procedure from 1 to 3
once again.
) .... The
) .... The sys-
"
"
" changes from fl ash-
English