Daikin FCQ18PVJU Operation Manual page 8

COOLING, HEATING, AUTOMATIC, FAN,
AND PROGRAM DRY OPERATION
Operate in the following order.
OPERATION MODE
1
SELECTOR
Press OPERATION MODE SELECTOR
button several times and select the
OPERATION MODE of your choice as
follows.
COOLING OPERATION ............................... "
HEATING OPERATION ................................. "
AUTOMATIC OPERATION ............................"
• In this operation mode, COOL/HEAT change-
over is automatically conducted.
FAN OPERATION ......................................... "
DRY OPERATION ......................................... "
• The function of this program is to decrease the
humidity in your room with the minimum tem-
perature decrease.
• Micro computer automatically determines
TEMPERATURE and FAN SPEED.
• This system does not go into operation if the
room temperature is below 60°F.
Refer to fi gure 3 on page [1]
2
ON/OFF
Press ON/OFF button.
OPERATION lamp lights up or goes off and the
system starts or stops OPERATION.
[EXPLANATION OF HEATING OPERATION]
DEFROST OPERATION
• As the frost on the coil of an outdoor unit in-
crease, heating effect decreases and the system
goes into DEFROST OPERATION.
• The indoor unit fan stops and the remote control-
ler display shows "
• After 6 to 8 minutes (maximum 10 minutes) of
DEFROST OPERATION, the system returns to
HEATING OPERATION.
English
"
"
"
"
"
".
Regarding outside air temperature and
heating capacity
• The heating capacity of the air conditioner de-
clines as the outside air temperature falls. In this
case, use the air conditioner in combination with
other heating systems.
• A warm air circulating system is employed, and
therefore it takes some time until the entire room
is warmed up after the start of operation.
• An indoor fan runs to discharge a gentle wind
automatically until the temperature inside the air
conditioner reaches a certain level. At this time,
the remote controller displays "
as it stands and wait for a while.
• When the warm air stays under the ceiling and
your feet are cold, we recommend that you use a
circulator (a fan to circulate the air inside the
room). For details, consult your dealer.
ADJUSTMENT
For programming TEMPERATURE, FAN SPEED
and AIR FLOW DIRECTION, follow the procedure
shown below.
TEMPERATURE SETTING
Press TEMPERATURE SETTING button and
program the setting temperature.
Each time this button is pressed,
setting temperature rises 1°F.
Each time this button is pressed,
setting temperature lowers 1°F.
• The setting is impossible for fan operation.
NOTE
• The setting temperature range of the remote
controller is 60°F to 90°F.
FAN SPEED CONTROL
Press FAN SPEED CONTROL button.
High or Low fan speed can be selected.
The microchip may sometimes control the fan
speed in order to protect the unit.
". Leave it
6